Transcription of Transfer Gear Pumps - Process Pump Sales
{{id}} {{{paragraph}}}
Example: bachelor of science
Transfer Gear Pumps - Process Pump Sales
Transfer gear PumpsConstruction of the gear Pump KFKRACHTGmbH Gewerbestr. 20 D-58791 Werdohl Tel. 02392/935-0 Fax 02392/935209 Internet: e-mail: FeaturesKF gear Pumps are used for pumping a wide variety of gear Pumps are distinguished especially by their wide range of variants which are assembled as required on the modular principle and also permit subsequent Pumps are also suitable for media with low standard housing sections are of grey cast iron. The gear units are manufactured from high-strength case-hardening steel, hardened and mounted in specialmulti-compound plain bearing standard drive shaft is sealed by rotary shaft pump sizes incorporate helical tooth system. This feature, combined with special gear geometry, results in extremely low noise levels and reduced pressure : Sealing of the drive shaftRotary shaft lip-type sealDouble rotary shaft lip-type seal (Quench)Mechanical seal Outboard bearing to take up input drive-side radial load Pressure relief valve as safety valve for pump and system Uniform discharge flow direction with changing directionof rotation by means of flange-mounting valve combination(universal device).
Flange-Type Pumps of Grey Cast Iron with Pressure Relief Valve d Seal + A
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: