Transcription of TROUBLESHOOTING AND MAINTENANCE
{{id}} {{{paragraph}}}
Example: barber
TROUBLESHOOTING AND MAINTENANCE
TROUBLESHOOTING AND MAINTENANCE 1 TROUBLESHOOTING 04 Objects Do Not Stick to the Build Plate 05 Objects are Difficult to Remove from the Build Plate 05 Extrusion Stops 06 Replicator 2X Shakes 07 Filament Not Loading 08 Filament Stuck 09 Disassembling an Extruder 10 lcd error Messages 11 Misaligned Nozzles 14 MakerBot MakerWare Error Messages 16 MakerBot Support 21 Dos and Don ts 21 Tools You May Find Useful 22 Diagnosing Print Quality Issues 23 2 MAINTENANCE 28 Leveling the Build Plate 29 Replacing Kapton Tape 31 Lubricating the Z-Axis Rod and Idler Pulley 32 Realigning the Gantry 34 Tightening the X- and Y-Axis Pulleys 35 Filament Care 36 Adjusting Extruder Spring Tension 36 TABLE OF CONTENTS3 TABLE OF CONTENTST roubleshooting1 PRINTING ISSUESINTRODUCTION5 TROUBLESHOOTINGOBJECTS DO NOT STICK TO THE BUILD PLATEIf printed objects are not sticking to the build plate, try these solutions: Re-level your build plate by going to theLCD menu and navigating to Uti
TROUBLESHOOTING 13 LCD ERROR MESSAGES CONTINUED Something might be wrong with your extruder. Please contact MakerBot Support by emailing support@makerbot.com. This is just an informational message. If you are loading or unloading filament, the process times out after five minutes. The onboard preheat sequence was interrupted by instructions ...
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: