Transcription of TYPICAL MANIFOLD SYSTEM - Franklin Electric
{{id}} {{{paragraph}}}
Example: bankruptcy
TYPICAL MANIFOLD SYSTEM - Franklin Electric
TYPICAL MANIFOLD SYSTEM4 TANKS RECOMMENDED TO BE OF SAME DIAMETERS OR WITH TOP OF TANKS ON THE SAME MUST CONFORM TO APPLICABLENATIONAL, STATE, AND LOCAL CODE REQUIREMENTSIN THIS TYPE OF INSTALLATION, A SUBMERGED PUMP INEACH TANK #1 & #2 SUPPLIES ONE DISCHARGE LINE. BYTHE USE OF VALVES AS SHOWN, ONE PUMP WILL SUPPLYTHE DISCHARGE LINE TEMPORARILY. TO USE SUBMESIBLETANK #1 ONLY, CLOSE VALVE "B" WITH VALVE "A" NORMALLYOPEN. TO USE SUBMERSIBLE TANK #2 ONLY, CLOSE VALVE "A"(FOR DISPENSING ONE PRODUCT WITH TWO SUBMERSIBLES)NORMALLY :2 SWING JOINT MAY BE APPLICABLE REPLACEMENT FOR FLEX CONNECTOR.
typical manifold system 4 tanks recommended to be of same diameters or with top of tanks on the same plane. installation must conform to applicable
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: