Transcription of “U” - UN-PUNCHED U-SHAPED CHANNEL, 54MIL (16GA STRUCTURAL)
{{id}} {{{paragraph}}}
technical ServicesTechnical Services: Engineering/ design : U - UN-PUNCHED U-SHAPED channel , 54 MIL ( 16ga STRUCTURAL) Geometric Properties U channels are fabricated in 3/4 , 1-1/2 , 2 , and 2-1/2 widths with 1/2 legs. All CEMCO U-SHAPED channels are produced from hot-dipped galvanized steel in standard G60 coating weight. G90 is available upon special ThicknessMil. ThicknessDesign Thickness (in.)1 MinimumThickness (in)1, ( mm) ( mm)Notes: 1. Uncoated steel thickness. Thickness is for carbon sheet steel. 2. Minimum thickness represents 95% of the design thickness and is the minimum acceptable thickness delivered to the job site, based on Section of the AISI Code (painted on ends): 54-mil: GreenASTM & Code Standards: ASTM A653/A653M, A924/A924M, & A1003/A1003M 2012 AISI 2012/2015 IBC 2010/2013 CBCLEED v3 for Building and design Construction MR Credit 2: Construction Waste Management.
Technical Services Technical Services: 800.416.2278 Structural Engineering/Design: 925.473.9340 www.cemcosteel.com “U” - UN-PUNCHED U-SHAPED CHANNEL, 54MIL (16GA STRUCTURAL)
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}
Technical Guide for Cold-Formed Steel Framing Products, Truss Design Manual, Cold, Formed, RESIDENTIAL FLOOR, Products, Residential Floor Framing, TM UNISTRUT, FRAMING, Technical, Design, Framing Systems Installation Manual, Elevate design, Stramit Purlins, Girts & Bridging, STRAMIT® PURLINS, GIRTS & BRIDGING