Transcription of USB DFU protocol used in the STM32 bootloader ...
{{id}} {{{paragraph}}}
Example: stock market
USB DFU protocol used in the STM32 bootloader ...
June 2021AN3156 Rev 121/23AN3156 Application noteUSB DFU protocol used in the STM32 bootloader IntroductionThis application note describes the USB DFU protocol used in STM32 microcontroller bootloader , detailing each supported document applies to the STM32 products embedding bootloader versions , , , , and as specified in AN2606 STM32 microcontroller system memory boot mode (available on ), which also contains more information about the USB hardware resources and requirements for the device bootloader . These products are listed in Table 1, and are referred to as STM32 throughout the document. Table 1. Applicable productsTypeSeriesMicrocontrollersSTM32F 0 SeriesSTM32F1 SeriesSTM32F2 SeriesSTM32F3 SeriesSTM32F4 SeriesSTM32F7 SeriesSTM32G0 SeriesSTM32G4 SeriesSTM32H7 SeriesSTM32L0 SeriesSTM32L1 SeriesSTM32L4 SeriesSTM32L5 SeriesSTM32WB Rev 12 Contents1 bootloader code sequence.
Note: Refer to Section 4 for more details about the valid memory addresses for the used device. The allowed number of bytes to read depends on the memory target: for the internal Flash memory, embedded RAM and system memory read size can be from 2 to 2048 bytes for the option bytes read size has to be equal to the option byte block size
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: