Transcription of Using the Command-Line Interface - Cisco
{{id}} {{{paragraph}}}
Example: quiz answers
Using the Command-Line Interface - Cisco
CHAPTER 1-1 Catalyst 3560 Switch command ReferenceOL-8554-051 Using the Command-Line InterfaceThe Catalyst 3560 switch is supported by Cisco IOS software. This chapter describes how to use the switch Command-Line Interface (CLI) to configure software features. For a complete description of the commands that support these features, see Chapter 2, Catalyst 3560 Switch Cisco IOS Commands. For information on the bootloader commands, see Appendix A, Catalyst 3560 Switch bootloader Commands. For information on the debug commands, see Appendix B, Catalyst 3560 Switch Debug Commands. For information on the show platform commands, see Appendix C, Catalyst 3560 Switch Show Platform Commands. For more information on Cisco IOS Release , see the Cisco IOS Release command Summary. For task-oriented configuration steps, see the software configuration guide for this this document, IP refers to IP version 4 (IPv4) unless there is a specific reference to IP version 6 (IPv6).
• For information on the bootloader commands, see Appendix A, “Catalyst 3560 Switch Bootloader Commands.” • For information on the debug commands, see Appendix B, “Catalyst 3560 Switch Debug Commands.” • For information on the show platform commands, see Appendix C, “Catalyst 3560 Switch Show Platform Commands.”
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: