Transcription of Visual Guide to the Accessibility Checklists
{{id}} {{{paragraph}}}
Visual Guide to the Accessibility Checklists Part I: Uniform Federal Accessibility Standard (UFAS) UFAS contains the design requirements deemed to comply with Section 504 of the Rehabilitation Act of 1973. The implementation date for the Agency was June 10, 1982. For the full text of UFAS, see: This Guide is not intended to address all Accessibility requirements of any Federal, State or local laws or regulations, nor should this information be relied on for that purpose. To ensure full compliance, borrowers, architects, agency officials, contractors and other interested persons should refer to the Uniform Federal Accessibility Standards and all other applicable Federal, State and local standards. The Owner(s) of the property are responsible for compliance with all applicable Accessibility regulations. Site: Parking #2 * PARKING SPACES. Parking spaces for disabled people shall be at least 96 in (2440 mm) wide and shall have an adjacent access aisle 60 in (1525 mm) wide minimum (see Fig.)
The inside handrail on switchback or dogleg ramps shall always be continuous. (2) If handrails are not continuous, they shall extend at least 12 in (305 mm) beyond the top and bottom of the ramp segment and shall be parallel with the floor or ground surface. (3) The clear space between the handrail and the wall shall be 1 -1/2 in (38 mm).
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}