Transcription of WATER HEATER SIZING GUIDE FOR ENGINEERS
{{id}} {{{paragraph}}}
Example: marketing
WATER HEATER SIZING GUIDE FOR ENGINEERS
PVI Industries, LLC Fort Worth, Texas WATER HEATER SIZING GUIDE FOR ENGINEERS COMMERCIAL INSTITUTIONAL INDUSTRIAL SIZING GUARANTEE PVI SIZING methods are guaranteed to be correct when used in accordance with the instructions as printed, as long as PVI equipment, with its unique performance characteristics, is used. If an installation should not have an adequate amount of hot WATER after proper use of the GUIDE , PVI will, at its cost, correct the installation to the engineer s satisfaction. COMMON FACTORS All calculated loads are converted to GPH (Gallons per Hour) 40 F to 140 F, or an 100 F rise. Appropriate conversion factors will be found near each formula. All BTU output calculations are based on RD (Recovery Demand) Requirement. All SR (Storage Requirements) are a percentage of the RD. CODES Some city, municipal, state and/or federal regulations may require different SIZING methods; they take precedence.
SIZING GUARANTEE PVI sizing methods are guaranteed to be correct when used in accordance with the instructions as printed, as long as PVI equipment, with its unique performance characteristics, is used. If an installation should not have an adequate amount of hot water after proper use of the Guide, PVI will, at its cost, correct
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: