Transcription of Wireless-N300 Range Extender On Quick Start Guide
{{id}} {{{paragraph}}}
Example: barber
Wireless-N300 Range Extender On Quick Start Guide
1. Power LED. On: RP-N12 is on RP-N12. Off: RP-N12 is off 2. Ethernet LED. Wireless-N300 Range Extender On: Device is connected to the Ethernet port. Quick Start Guide Off: Device is not connected to the Ethernet port. 3. Wi-Fi LED. Green: RP-N12 provides the best Wi-Fi Extender performance. Red: RP-N12 provides poor Wi-Fi Extender performance. Off: RP-N12 is not connected to a Q10205 router/AP. First Edition NOTE: Please refer to step 3 in Method March 2015. One for the best Wi-Fi performance. Method One Quick Setup with WPS (Wi-Fi Protected Setup). For router/Access Point(AP) with WPS support 1 Power On Place your RP-N12 near your router/AP and plug it to 2 Connect via WPS (Wi-Fi Protected Setup) The Wi-Fi LED flashs for about two (2) minutes and then turns solid green or a power outlet.
Connect your wireless devices to the new Extender network. Enjoy! Your RP-N12’s wireless network name (SSID) changes to your existing Wi-Fi network name, ending with _RPT and shares your router/AP’s Wireless Password. Media Bridge (Ethernet Adapter)
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: