Transcription of www.BetaMachinery.com Foundation And Skid …
{{id}} {{{paragraph}}}
Foundation And Skid Design Considerations For Large, high - speed Reciprocating Compressors > New GMRC Guideline will draw on industry best practices By Norm Shade piers (equipment mounted on a con- crete block supported by deep driven steel piers), block and skid on driven steel pilings (equipment mounted on a fabricated steel skid mounted on a concrete block supported by driven steel pilings), and skid on driven steel pilings (equipment mounted on a fab- ricated steel skid mounted on driven steel pilings). high - speed reciprocating com- pressors are much more likely to be installed on a skid than classic slow- speed models. The skid is the fabri- cated steel structure that supports the compressor and driver and often the n Figure 1. Shown above is a common arrangement of a skid-mounted motor/ vessels, piping and other equipment compressor package.
OCTOBER 2012 COmpREssORtech2 I n the past decade, high-speed (700 rpm and above) reciprocat-ing compressors have become common for gas transmission and
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}