www.mainelectronics

TO PROGRAM A DSC SYSTEM A TUTORIALOur goal is to show you how to enter values into the DSC operating system, not to tell you what thosevalues should be (although we will include some examples of values that you may wish to program). We previously based the instructions on a Power 832/PC 5010, and although the new line of DSCpanels is programmed in the same way, there are a few differences. Please note that if you have asystem that pre-dates the "Power Series," you will find significant differences from the valuesdiscussed here (two-digit section numbers, for example). However, the same programming methodscan be applied to any DSC system. If you have a 5500 keypad, (either the old LCD5500 or the new PKor RFK5500) so much the better, but none of the programming techniques that will be discussed hereare keypad-dependent, and programming can be accomplished with any important: Before you even attempt to begin programming, you should have a programmingworksheet in front of you.

www.mainelectronics.com When you finished programming section 001, you pressed ##. The first # got you out of section 001, and the second # got you out of programming altogether.

Loading..

Tags:

  Mainelectronics

Information