Transcription of Z-Plus Upgrade
{{id}} {{{paragraph}}}
Z-Plus Upgrade ASSEMBLY GUIDE. 8/26/2020 Version 1. Table of Contents Introduction .. 3. Inventory .. 4. Disconnect the BitSetter .. 7. Part 1: Disassembly .. 8. Disassemble the Existing 8. Part 2: Assembly & Installation .. 11. Install the Drag Chain Support System .. 15. Insert the Proximity Switch Cables into the Drag Chain .. 19. Install the Z-Plus .. 21. Install the Drag Chain .. 23. Install the Proximity 25. Connect the Wiring .. 28. Cleanup the Cables .. 30. Part 3: Post Installation .. 33. Tramming Instructions .. 33. Update Your Machine Settings .. 35. 8/26/2020 Version 2. Introduction We're here to help!
two (2) nylon lock nuts securing the drag chain to the head bracket. 5. Disconnect the Y-Axis drag chain from the Y-Axis head bracket on the outside of the Y1-carriage. a. Use a 2mm hex key and needle nose pliers to remove the two (2) M3×8mm FHS and two (2) nylon lock nuts securing the drag chain to the head bracket. 6.
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}