485 converter
Found 8 free book(s)
AIC+ Advanced Interface Converter - Rockwell Automation
literature.rockwellautomation.comOperation Modes The AIC+ interface converter can be used in the following modes. • Point-to-point isolator • RS-232 to RS-485 isolator • RS-232 to half-duplex user mode ASCII isolator Communication is established using hardware handshaking or auto transmit signals. Device Compatibility The AIC+ interface converter can be used to ...
MS/TP Communications Bus Technical Bulletin
cgproducts.johnsoncontrols.comconverter, including the Johnson Controls® BACnet to MS/TP Router (TL-BRTRP-0). Use a Remote Field Bus for applications where connecting an RS-485 network directly to a network engine is not practical because of distance, cost, or poor accessibility. In …
Temperature Measurement with a Thermistor and an …
web.cecs.pdx.eduNotice how the resolution of the analog to digital converter (ADC) on the Ar-duino causes discontinuous jumps in the measured value of R t. When the value of Vo changes from 487 to 488, the value of Rt jumps from 10863 ... 485 10948.58 22.37 485 10948.58 22.37 485 10948.58 22.37 483 11034.78 22.17...
Engineered with TIA Portal Be flexible thanks to ... - Siemens
assets.new.siemens.com150 KB program memory, DI 10 x 24 V DC, DI 4 x RS422/485, DQ 6 x 24 V DC, DQ 4 x RS422/485, AI 2 x 0–10 V DC, AQ 2 x 0–20 mA, 2 x PROFINET Port DC/DC/DC 6ES7217-1AG40-0XB0 F-CPUs CPU 1212FC 100 KB program memory, DI 8 x 24 V DC, DQ 6 x 24 V DC or 6 x RLY, AI 2 x 10 bits 0–10 V DC DC/DC/DC 6ES7212-1AF40-0XB0 DC/DC/RLY 6ES7212 …
CompactLogix™ System - Rockwell Automation
literature.rockwellautomation.comThe messaging over DH-485 example (previously in an appendix) was moved to the Communicating with Devices on DH-485 chapter to make the information more accessible.
28/40/44-Pin, Low-Power, High-Performance Microcontrollers ...
ww1.microchip.com- Supports RS-485, RS-232 and LIN - RS-232 operation using internal oscillator - Auto-Wake-up on Break - Auto-Baud Detect TABLE 1: PIC18(L)F2X/4XK22 FAMILY TYPES Device Program Memory Data Memory I/O (1) 10-bit A/D Channels (2) CCP ECCP (Full-Bridge) ECCP (Half-Bridge) MSSP EUSART Comparator CTMU BOR/LVD SR Latch 8-bit Timer 16-bit Timer
AVR128DB28/32/48/64 Data Sheet - Microchip Technology
ww1.microchip.com• Operation modes: RS-485, LIN slave, master SPI, and IrDA • Fractional baud rate generator, auto-baud, and start-of-frame detection – Two SPIs with master/slave operation modes – Up to two Two-Wire Interface (TWI) with dual address match • Independent master and slave operation Dual mode) AVR128DB28/32/48/64
LPC1769/68/67/66/65/64/63 Product data sheet - NXP
www.nxp.comOne UART has modem control I/O and RS-485/EIA-485 support, and one UART has IrDA support. CAN 2.0B controller with two channels. (Not available on all parts, see Table 2.) SPI controller with synchronous, serial, full duplex communication and programmable data length. Two SSP controllers with FIFO and multi-protocol capabilities.