Fasteners Masonry Fastener Technical Data And
Found 5 free book(s)
Technical Document Seismic Technical Guide
www.usg.comfasteners in masonry are not permitted unless approved for seismic loading. Exception : Power actuated fasteners in concrete used for support of acoustical tile or lay-in panel suspended ceiling applications and distributed systems where the service load on any individual fastener does not exceed
ARCHITECTURAL WALL PANELS | AWP1818, AWP3030 …
www.nichiha.comcalculated wind load performance data for our products to determine whether and how the panels can safely be ... masonry, or concrete based product, when cutting, drilling, sawing, ... fastener design for anchoring the furring to structure. Refer to IBC 2015 Table 2603.12.2 for more info.
Technical Guide: DensGlass® Sheathing
floridabuilding.org• Fasteners should be driven flush with the panel surface (not countersunk) and into the framing system. Locate fasteners at least 3/8” (9 mm) from the ends and edges of the sheathing. Nails or screws, as listed in the fastener chart, may be used to attach DensGlass Sheathing to framing.
HARDIPLANK Installation Instructions
www.structuretech1.com• Drive fasteners perpendicular to siding and framing. • Fastener heads should fit snug against siding (no air space). (Fig. A & B) • Do not over-drive nail heads or drive nails at an angle. • If nail is countersunk, caulk nail hole and add a nail. (Fig. C) NAIL TYPE: Fasteners …
Hilti - 2011 Anchor Fastening Technical Guide
www.buildsite.comAnchor Fastening Technical Guide 1.0 Introduction 4 Hilti, Inc. (US) 1-800-879-8000 | www.us.hilti.com I en español 1-800-879-5000 I Hilti (Canada) Corp. 1-800-363-4458 I www.hilti.ca I Anchor Fastening Technical Guide 2011 1.1 A bout Published Load Values The Anchor Fastening Technical Guide is intended to We passionately create enthusiastic …