High Voltage Differential Probes Installation And
Found 3 free book(s)
USB-6212 Specifications - National Instruments
www.ni.comIOH output high current -16 mA maximum Digital Input Characteristics Level Minimum Maximum VIL input low voltage 0 V 0.8 V VIH input high voltage 2.2 V 5.25 V IIL input low current (Vin = 0 V) - -10 μA IIH input high current (Vin = 5 V) - 250 μA 1 Stresses beyond those listed under Input voltage protection may cause permanent damage to the ...
USB-6210 Specifications - National Instruments
www.ni.comVoltage 4.6 V to 5.2 V Current (internally limited) 50 mA maximum, shared with digital outputs +5 V terminal as input3 Voltage 4.75 V to 5.35 V Current 350 mA maximum, self-resetting fuse Caution Do not exceed 16 mA per DIO pin. Protection ±10 V Power Requirements Input voltage on USB port 4.5 V to 5.25 V in configured state Maximum inrush ...
Installing and Operating Instructions
www.dixell.co.ildifferential from the set point: if the temperature increases and reaches set point plus differential the compressor is started and then turned off when the temperature reaches the set point value again. Time Temper. Compr. SET ON In case of fault in the thermostat probe the start and stop of the compressor are timed through