Example: air traffic controller

Quiescent Current 250

Found 5 free book(s)
LT1083/LT1084/LT1085 - 7.5A, 5A, 3A Low Dropout Positive ...

LT1083/LT1084/LT1085 - 7.5A, 5A, 3A Low Dropout Positive ...

www.analog.com

rent is wasted as quiescent current, the LT1083 quiescent current flows into the load, increasing efficiency. FeaTures applicaTions n 3-Terminal Adjustable n Output Current of 3A, 5A or 7.5A n Operates Down to 1V Dropout n Guaranteed Dropout Voltage at Multiple Current Levels n Line Regulation: 0.015% n Load Regulation: 0.1%

  Current, Quiescent current, Quiescent

LT3082 - 200mA Single Resistor Low Dropout Linear Regulator

LT3082 - 200mA Single Resistor Low Dropout Linear Regulator

www.analog.com

Since all quiescent and drive current is delivered to the output of the part, the minimum load current is the minimum current required to maintain regulation. Note 4: For the LT3082, dropout is specifi ed as the minimum input-to- ... –250 –200 –150 …

  Current, Quiescent

AP2112 VOUTIN 600mA CMOS LDO ... - Diodes Incorporated

AP2112 VOUTIN 600mA CMOS LDO ... - Diodes Incorporated

www.diodes.com

= 600mA — 250 400 I Q Quiescent Current V IN = 3.5V, I OUT = 0mA — 55 80 µA I STD Standby Current V IN = 3.5V, V EN in OFF mode — 0.01 1.0 µA PSRR Power Supply Rejection Ratio Ripple 0.5Vp-p V IN = 3.5V, I OUT = 100mA f = 100Hz — 65 — dB f = 1KHz — 65 — (∆V OUT /V OUT)/∆T Output Voltage Temperature ...

  Current, Quiescent current, Quiescent

CD405xB CMOS Single 8-Channel Analog Multiplexer ...

CD405xB CMOS Single 8-Channel Analog Multiplexer ...

www.ti.com

ON impedance and very low OFF leakage current. These multiplexer circuits dissipate extremely low quiescent power over the full VDD – VSS and VDD – VEE supply-voltage ranges, independent of the logic state of the control signals. Device Information(1) PART NUMBER PACKAGE BODY SIZE (NOM) CD405xB CDIP (16) 19.50 mm× 6.92 PDIP (16) 19.30 mm ...

  Current, Quiescent

LM393B, LM2903B, LM193, LM293, LM393 and LM2903 Dual ...

LM393B, LM2903B, LM193, LM293, LM393 and LM2903 Dual ...

www.ti.com

current, lower input bias current, lower propagation delay, and improved 2 kV ESD performance and input ruggedness through dedicated ESD clamps. The LM393B and LM2903B can drop-in replace the LM293, LM393 and LM2903, for both "A" and "V" grades. All devices consist of two independent voltage comparators that are designed to operate from a

  Current

Similar queries