2022 MODIFIED RULES
mounted solid to axle tube with lower link OR one floating birdcage with upper and lower links allowed per side. Additional shock/coil-over eliminator clamp bracket solidly mounted to axle tube is allowed per side. Steel coil-over eliminators, or steel or aluminum coil-over kits allowed - must conform to shock and spring rules. Shocks and
Download 2022 MODIFIED RULES
Information
Domain:
Source:
Link to this page:
Documents from same domain
IMCA Racing, 1800 West D Street, P.O. Box 921, Vinton, IA ...
www.imca.comwall thickness. Minimum three door bars, both sides, parallel to ground, and perpendicular to driver. Minimum four uprights tied from frame to top door bar on driver side, and minimum three uprights on passenger side. Steel door plates, 18 gauge or 0.049 inch minimum thickness, must be securely welded to outside of door bars on driver’s side.
2022 HOBBY STOCK RULES - imca.com
www.imca.comhorns together) for radiator protection; must be behind bumper, within confines of body, no wider than OEM frame horns. Rear kickers (down bars) and engine hoop required, and must be minimum 1.25 inch O.D. tubing with 0.083 inch wall thickness. Fuel cell protection
IMCA Racing, 1800 West D Street, P.O. Box 921, Vinton, IA ...
www.imca.comdoor bar to frame and from rear down post to five inches in front of seat. Must be visible for inspection. 5.BODY: Must be an approved, unaltered OEM or OEM replacement body and centered over wheel wells (front to rear and side to side). Body and engine make must match. May use 1988-to present
2022 HOBBY STOCK RULES
www.imca.comfirewall, 18 gauge or minimum 0.049 inch thickness. Front firewall may be no further back than the rear of oval frame hole, must be vertical and 24-26 inches tall. All holes in firewalls and floor must be covered. OEM floor may be replaced from OEM front firewall to OEM rear firewall using steel fabricated floor pan, 18 gauge or minimum 0.049 inch
2022 NORTHERN SPORTMOD RULES
www.imca.comis in competition except brake adjuster. No mirrors of any kind. 7. FRONT SUSPENSION: All components must be steel, unaltered OEM, in OEM location, and replaceable by OEM parts. Exceptions are: tube-type upper A-frames with or without aluminum or steel cross shaft, and mounts can be moved; stamped steel OEM replacement lower A-frames; rubber ...
Related documents
Part 1 - FIRST
www.firstinspires.org• Make sure that set screws are installed in every axle hub, motor hub, and axle collar. • Refer to the legend provided in the Kit of Parts, if any parts are unfamiliar. ... Step 3: Add Floating Screws to Beam Parts Needed: Back Support Assembly (1 - …
Go there - Kia Motors South Africa
www.kia.co.zaNew 8-inch Floating Touch Screen* * Available on all models, except Start Images shown may contain vehicles, specifications or colours that are model specific, that may not be available in this country, or may be fitted with optional extras. For exact information, please consult your nearest KIA dealership. Errors and omissions excepted (E&OE).