2GR-FKS Engine
The crankshaft bearing caps are tightened using 4 plastic region tightening bolts (crankshaft bearing cap set bolts) for each journal. In addition, each cap is tightened laterally to improve its reliability. Text in Illustration *1 Plastic Region Tightening Bolt (Crankshaft Bearing Cap Set Bolt) *2 Crankshaft Bearing Cap *3 Seal Washer *4 Resin ...
Download 2GR-FKS Engine
Information
Domain:
Source:
Link to this page:
Related documents
Safety Wire - Federal Aviation Administration
www.faa.gov1) safety wire, 2) cotter pins, and 3) self-locking nuts. Wire: usually stainless steel, used on cylinder studs, control cable turnbuckles, and engine accessory attaching bolts. Cotter pins: used on aircraft and engine controls, landing gear, and tailwheel assemblies,
ASTM A193/A193M B8 and B8M Class 1 Torque-Tension Guide
www.fastenal.comASTM A193/A193M B8 and B8M Class 1 Torque-Tension Guide 1/4 20 0.0318 716 29 in-lbs 33 in-lbs 382 ... Stainless steel fasteners tend to gall, especially with long run downs, prevailing torque fasteners, ... Tightening Torque Dry Clamp Lubricated Dry Load (lbs.) K = 0.16 14 16 21 25 K = 0.35 Coarse Thread Series 59 69 75 88
SELF-LOCKING FASTENERS
www.pemnet.comM3 x 0.5 CFN M3 1 1.02 1.1 3.86 4.11 4.45 5.16 2.65 2.93 CFN™ BROACHING LOCKNUT • For thinner sheets, close-to-edge applications. • Prevailing torque locking element provides torque to eliminate loosening of mating threaded hardware. All dimensions are in inches. All dimensions are in millimeters. CFN – 440 – 1 ZI Finish Code
SKF Vibracon
www.skf.comSM 30 LP-ASTR M30 20 25 30 20 140 37 6 2 1,8 SM 36 LP-ASTR M36 30 35 40 30 160 44 6 2 3,7 SM 42 LP-ASTR M42 35 40 45 35 190 50 6 2 6,2 Technical data Stainless steel chocks (-SS) In harsh conditions, where requirements cannot be met by carbon steel surface treated chocks, the stainless steel chocks will be the solution. Mating surfaces are ...