An Introduction to Petroleum Fuel Facilities: Piping Systems
Wherever possible, arrange piping in parallel groups to facilitate multiple use of supports, to minimize the amount of trenching for underground piping, and to minimize the number of steps or stiles needed across pipe runs. For underground applications, consider constructability when determining amount of spacing between pipes.
Download An Introduction to Petroleum Fuel Facilities: Piping Systems
Information
Domain:
Source:
Link to this page:
Documents from same domain
Open Channel Flow I - The Manning Equation and Uniform …
www.titance.comIn this course several aspects of open channel flow will be presented, discussed and illustrated with examples. The main topic of this course is uniform open channel flow, in which the channel slope, liquid velocity and liquid depth remain constant. First, however, several ways of classifying open channel flow will be presented and discussed ...
Related documents
Installing PVC Pipe in Underground Applications
www.charlottepipe.comFlexible piping systems like ABS or PVC have less structural strength than rigid metallic piping systems, which is an important consideration when designing systems buried in unstable soil. Burial of pipe beneath a building built on unstable soil is often accomplished by suspending piping systems from structural slabs.
STANDARD SPECIFICATIONS FOR ROADS AND STRUCTURES - …
connect.ncdot.govnorth carolina department of transportation raleigh standard specifications for roads and structures january 2018
CONSTRUCTION GUIDE - Baltimore Gas and Electric
www.bge.com6. Installation of gas piping into any electrical conduit bank is prohibited. 7. Installation of minimum 4” sleeve and underground warning tape unless otherwise specified for natural gas service under paving, or under improved areas as required by BGE or any city or county regulations. (Applicable only for
FACT SHEET - American Gas Association
www.aga.orgpiping system using a flexible metal gas appliance connector, the connector has been found to provide an adequate electrical connection between the appliance and the gas piping, and have been considered sufficient to meet the NEC ® requirements for bonding connectivity. To prevent corrosion of the utility’s underground metallic service line, a
Fire Protection Underground Piping - CSRA SFPE
csra-sfpe.org4. Underground piping must be restrained with thrust blocks 5. All fire protection lines must be equipped with a Post Indicator Valve 6. The top of a PIV shall be set so the top is 40 inches above valve 7. Hydrants must be located at least 40 feet from the building protected 8. FP underground may not be run underneath a building 9.
INTERNAL PLUMBING CODE PRESENTATION BASED ON …
www.maine.gov(1) Underground inspection shall be made after trenches or ditches are excavated and bedded, piping installed, and before backfill is put in place. • (2) Rough-in inspection shall be made prior to installation of wall or ceiling membranes. • (3) Final inspection shall be made upon completion of …
1.0 JOINT FIT-UP AND ALIGNMENT - Los Alamos National ...
engstandards.lanl.govAttachment 3, ASME B31.8, Gas Transmission & Distribution Piping Alignment and Acceptance Criteria 1.6 In assembly of socket weld joints, the pipe or tube shall be withdrawn a distance of approximately 1/ 16 in. away from contact between the end of the pipe and the face of the shoulder of the socket.