BigStuff3 - GEN3
maximum and a .125 Watt min (to 2 Watt max) resistor is needed. A resistor is not required with the MSD Super 8 ignition system. Installation of the relay will be addressed later in this manual.
Download BigStuff3 - GEN3
Information
Domain:
Source:
Link to this page:
Documents from same domain
System Hardware Installation & BigComm …
bigstuff3.comGEN3 PRO SEFI System System Hardware Installation & BigComm Software User Instruction Manual Revision 2.1 – December 2010
System Hardware Installation & BigComm …
bigstuff3.comGEN3 PRO SEFI System (LS1) System Hardware Installation & BigComm Software . User Instruction Manual Revision 1.0
Electrical Pinouts for BS3-004-002
bigstuff3.comElectrical Pinouts for BS3-004-007 - Base System DAI/DAE)
February 2009 – Rev 1 - BigStuff3
bigstuff3.comvalue in the Crank Trigger window (in the Operating Configuration table), up or down, until the “Dash” value and the crank value are the same.
GEN3 PRO SEFI DAE Option - User Manual - …
bigstuff3.comBigstuff3 GEN3 PRO SEFI DAE Option - User Manual Turbo Shaft Speed This connector must interface with a two (2) wire Variable Reluctance (VR) style sensor (not a hall-
Modifying an LS1 Coil-on-Plug (COP) System to Use an ...
bigstuff3.comRev 1.0 – Feb 2011 1 GEN3 PRO SEFI System Modifying an LS1 Coil-on-Plug (COP) System to Use an External 24X Wheel and Sensor
GEN3 Upgrade Options - BigStuff3
bigstuff3.comPhone (248)732-2846 www.bigstuff3.com GEN3 Upgrade Options • GM transmission control (4L60/80E). • Stand-alone, LS1/2/7 and Ford MOD motor coil-on-plug systems.
GEN3 Powertrain Controller Transmission Control User’s …
bigstuff3.comBigstuff3 GEN3 Transmission Control Manual Transmission Control – System Contents The transmission control option is sold with this user’s manual and the standalone transmission wire