CIVIL ENGINEERING DRAWING
Plinth is the portion of the structure between the surrounding ground level and the surface of the floor level immediately above the ground is termed as plinth. The level of the plinth is usually called as plinth level and the built up area at the floor level is known as plinth area. The plinth height in any case shall not be less than 450mm.
Download CIVIL ENGINEERING DRAWING
Information
Domain:
Source:
Link to this page:
Documents from same domain
BUILDING MATERIALS & CONSTRUCTION
bie.tg.nic.inAll the building structures are composed of different types of materials. These materials are either called building materials or materials of construction. It is very essential for a builder, may be an architecture or engineer or contractor, to become conversant thoroughly with these building materials.
A Text Book on Automobile Chassis And Body Engineering …
bie.tg.nic.instub axle. 4. Cam and Lever Type: The cam and lever steering uses one or two lever studs fitted in taper roller bearing. When the worm in the form of helical groove rotates the stub axle and it also rotates along with it. This imports a turning motion to the drop arm shaft. 5. Worm and Sector Type: In this type the worm on the end of the steering
Related documents
GOVERNMENT OF ANDHRA PRADESH A B S T R A C T
crda.ap.gov.in(c) Buffer Area is the area within which certain structures / sensitive uses are either restricted or prohibited. (17) Building (a)A structure constructed with any materials whatsoever for any purpose, whether used for human habitation or not, and includes:- (i) Foundation, plinth, walls, floors, chimneys, plumbing and building
IS 3861 (2002): Method of Measurement of Plinth, Carpet ...
law.resource.org4.1 Plinth area shall be the built up covered areas measured for the categories mentioned in 3.2 and shall include such areas as given in 4.1.1 and exclude the areas given in 4.1.2. 4.1.1 For the purpose of plinth area, following shall be included: a) Area of the wall at the floor level excluding
GENERAL BUILDING REQUIREMENTS
mohua.gov.in** The plinth or covered area shall include, in addition to the main assembly room or space, any occupied connecting room or space in the same storey or in the storeys above or below where entrance is common to such rooms and space and the …