Example: dental hygienist
COMPUTER NUMERICAL CONTROL PROGRAMMING BASICS

COMPUTER NUMERICAL CONTROL PROGRAMMING BASICS

Back to document page

When points are located on a workpiece, two straight intersecting lines, one vertical and one horizontal, are used. These lines must be at right angles to each other, and the point where they cross is called the origin, or zero point (Fig. 1) Fig. 1 Intersecting lines form right angles and establish the zero point (Allen-Bradley)

  Computer, Control, Points, Numerical, Computer numerical control

Download COMPUTER NUMERICAL CONTROL PROGRAMMING BASICS


Information

Domain:

Source:

Link to this page:

Please notify us if you found a problem with this document:

Other abuse

Advertisement

Related search queries