CONCRETE ANCHOR GUIDE
1. Not fully expanding a drop-in anchor because the wrong setting tool was used or the operator simply "felt” that the anchor was set. 2. Setting a stud anchor at too shallow a depth because it was on top of a rebar. 3. Setting a capsule anchor by simply driving the threaded stud into the capsule and not spinning it.
Download CONCRETE ANCHOR GUIDE
Information
Domain:
Source:
Link to this page:
Related documents
2013 EDGE Owner’s Manual
www.fordservicecontent.comlower anchor Child seat tether anchor Cruise control Do not open when hot Engine air filter Engine coolant Engine coolant temperature Engine oil Explosive gas Fan warning Fasten safety belt Front airbag Front fog lamps Fuel pump reset Fuse compartment Hazard warning flasher 10 Introduction 2013 Edge (edg) Owners Guide gf, 4th Printing, November ...
©2011 RIVETKING® RIVET CATALOG
www.rivetking.infoTo act as a guide peg or anchor stud for a pivoting assembly. May be supplied completely solid or Semi Tubular as shown. Can be applied/fed with auto feed machines. PAGES 01,02 SEmi TUBULAR dEEP-HoLE To permanently fasten two or more pieces to relatively soft materials such as leather, cardboard, canvas, rubber,
BONDEK STRUCTURAL STEEL DECKING - Lysaght
professionals.lysaght.comTechnical Sales Representative to provide additional information. 3 BONDEK ® DESIN ND ... 7.3.9 Fastening side-lap joints 36 7.3.10 Cutting and fitting Edgeform 36 ... 7.9.2 BONDEK® rib removal at PT anchor points or stressing pans 43 7.9.3 Positioning of …
Network Rail A Guide to Overhead Electrification
www.bathnes.gov.uk2 of 52 Network Rail Guide to Overhead Electrification 132787-ALB-GUN-EOH-000001 / February 2015 Rev 10 Alan Baxter 2.0 Definitions 2.0 Definitions The intention of this guide is to explain OLE to a non-technical audience. To that end, we have tried wherever possible to describe electrification in non-professional terms.
Hilti - 2011 Anchor Fastening Technical Guide
www.buildsite.comThe Anchor Fastening Technical Guide is intended to We passionately create enthusiastic customers and build supplement the Hilti Product and services catalog with technical information for the designer or specifier. Technical data presented herein was current as …
KWIK-CON II+ CONCRETE AND MASONRY SCREW - Hilti
www.hilti.comContact Hilti Technical Services for applications and conditions not addressed in the (IFU)/Operating Instructions (OI). Load values are for anchors installed a minimum of sixteen diameters on center and a minimum edge distance of sixteen diameters. Anchor spacing may be reduced to twelve diameters provided loads are reduced by 20 percent.
233 /255 Pilaster Standards and Supports
www.knapeandvogt.comFastening: Inadequate or incorrect fasteners can result in the standards pulling loose and causing damage. Alignment: Improper standard and clip alignment can result in a system that is ineffective and unsafe. 5. Installation 233 Pilaster Standards can be installed on the surface. The 233 Pilaster Standard can be mounted with nails, staples, or ...
Wood-Frame Shear Wall and Diaphragm Design
www.woodworks.orgWood-Frame Shear Wall and Diaphragm Design Ricky McLain, MS, PE, SE Technical Director –WoodWorks Texas Workshops –December, 2016