DOCUMENT ON TEST METHOD, TESTING EQUIPMENT AND …
doc.no.: morth/cmvr/tap-115/116 issue no. 4 testing type approval and conformity of production (cop) ministry of road transport and highways, government of india march, 2010 issued by the automotive research association of india s. no. 102, vetal hill, off paud road, kothrud, pune – 411 038 document on test method, testing equipment and related
Download DOCUMENT ON TEST METHOD, TESTING EQUIPMENT AND …
Information
Domain:
Source:
Link to this page:
Documents from same domain
AMENDMENT No. 1 TO Doc. No.: MoRTH/CMVR/ TAP …
www.araiindia.com2.0 Part II 2.1 Clause 3.4.2 Substitute following text for existing text: In cases where an engine has several exhaust outlets; these shall be connected
Chapter 4 CHASSIS DYNAMOMETER 1. Definition of a Chassis ...
www.araiindia.com3.1.5.1.Preparation: Perform the operations specified in 5.1.2.2.1 to 5.1.2.2.4 of Section II of this chapter. 3.1.5.2.Setting: After warm-up, drive the vehicle at a steady speed of 80 km/h and adjust dynamometer load to reproduce the vacuum reading (v) obtained in accordance with 3.1.4.3. Deviation from this reading must be no greater than 0 ...
List of ARAI Publications - Automotive Research And ...
www.araiindia.comPermissible Levels and Methods of Tests. Electromagnetic Radiated Immunity of Automotive Vehicles – Requirements and Methods of Tests Automotive Vehicles – Requirements for Electromagnetic Compatibility 2. AIS-008 / 2001 Amd.No.1 ...
TAP Document Issue 4 Volume III PART XIII to XV - ARAI India
www.araiindia.comto the settings for idling and for the cold start device, and exhaust gas cleaning systems, etc. 3.1.5. The vehicle to be tested, or an equivalent vehicle, shall be fitted, if necessary with a device to permit the measurement of characteristic parameters …
Related documents
TAP Document Issue 4 Volume III PART XIII to XV - ARAI India
www.araiindia.comMoRTH / CMVR / TAP-115/116 (Issue 4) Page 897 3. Vehicle and Fuel 3.1. Test Vehicle: 3.1.1. The vehicle presented shall be checked that it is the same model as specified as per format of chapter 2 of this Part. It shall have been run-in either as per manufacturer's specification or at least 3000 km before the test. 3.1.2.