Floor Flatness and Levelness Testing - The Complete ...
6. American Concrete Institute (ACI) 117-10 "Specification for Tolerances for Concrete Construction and Materials and Commentary". Jerry A. Holland, P.E., F.ACI, is a Principal, Vice-President and the Director of Design Services for Structural Services, Inc. He is on several ACI committees, teaches seminars for ACI and the World of Concrete.
Download Floor Flatness and Levelness Testing - The Complete ...
Information
Domain:
Source:
Link to this page:
Related documents
318-11 Building Code Requirements for Structural Concrete ...
www.engineervincentpardopilien.weebly.comACI 318-11 was adopted as a standard of the American Concrete Institute May 24, 2011, to supersede ACI 318-08 in accordance with the Institute’s standardization procedure and was published August 2011. A complete metric companion to ACI 318 has been developed, 318M; metric equivalents are provided only in Appendix F of this document.
Best Practices for Jointing of Concrete Pavements
intrans.iastate.edu- Last 3 transverse joints receive tiebars - Last longitudinal joint receives tiebars o Except. When it is a construction joint AND the pavement is . greater than 6” in thickness (then use dowels) • Commercial Aviation runways - Last 3 transverse contraction joints are doweled - All longitudinal construction joints are doweled
ACI 360R-10 Guide to Design of Slabs-on-Ground
www.concrete.orgOrder information: ACI documents are available in print, by download, on CD-ROM, through electronic subscription, or reprint and may be obtained by contacting ACI. Most ACI standards and committee reports are gathered together in the annually revised ACI Manual of Concrete Practice (MCP). American Concrete Institute 38800 Country Club Drive
The Reorganized ACI 318-14 Code - Iowa State University
www.extension.iastate.eduACI 318-11 Language 21.9.9 — Construction joints All construction joints in structural walls shall conform to 6.4 and contact surfaces shall be roughened as in 11.6.9. 6.4.3 — Construction joints shall be so made and located as not to impair the strength of the structure. Provision shall be made for transfer of shear and other forces through