HDPE Pipe Pressure Rating Temperature Guidelines
This is done by the Plastics Pipe Institute (PPI). Concurrent with the ... The recognized method for determining the long-term performance of thermoplastic ... specifications still call out PE3408 material, both standards allow pipe to be supplied with dual markings. That is, a pipe could be marked as PE3408/3608 or PE3408/4710 because the
Download HDPE Pipe Pressure Rating Temperature Guidelines
Information
Domain:
Source:
Link to this page:
Documents from same domain
TN-38: Bolt Torque for Polyethylene Flanged Joints
hdpesupply.comBy applying the higher initial seating torque to seat the un-marred HDPE faces, without gaskets, the final residual bolt torque(RBT) at the HDPE sealing stress is sufficient to contain flow-stream pressure under operating conditions. As is discussed later, the mandatory re-torquing to the initial target torque after a 4 hour to 24
HEAT FUSION JOINING PROCEDURES - Hdpe Supply
hdpesupply.comReliable fusion joints of PE piping systems can be accomplished under reasonable latitude of conditions. The operator should qualify its own procedures for every condition under which it will be fusing polyethylene pipe. Additionally, the operator should qualify all personnel who will responsible for performing fusions of polyethylene pipe.
for POTABLE WATER - Hdpe Supply
hdpesupply.comThermal Expansion Coefficient -4 2x10 cm/cm/°C 1.0x10-4 in/in/°F CELL CLASSIFICATION: D3350 445574C PE47 445576C PE100 PPI HYDROSTATIC DESIGN BASIS (HDB) D2837 11.0 MPa @ 23°C 1,600 psi @ 73.4°F (As listed in PPI TR-4) 6.9 MPa @ 140°C 1,000 psi @ 140°F PPI HYDROSTATIC DESIGN STRESS (HDS) 6.9 MPa @ 23°C 1,000 psi @ 73.4°F
HDPE Fittings and Equipment Product Catalog
hdpesupply.com4 www.IntegrityFusion.com Order & Price Information Pricing: Please contact Integrity Fusion Products, Inc, or your local authorized distributor for pricing inquiries. We welcome all inquiries via telephone, email, or fax. Phone: 770-632-7530 Fax: 770-632-7540 E-mail: [email protected] Ordering: Minimum Billing: $50.00 (orders less than $50.00 will be …
Guidance for Field Hydrostatic Testing Of High Density ...
hdpesupply.comPolyethylene pipe is a lower modulus visco-elastic material that dilates in diameter (creep-strains) when subjected to higher stress during hydrotest. This means that for a fixed volume of clean fill water, the hydrostatic pressure will decline slightly during the test time, as the polyethylene molecular chains stretch and align under high stress.
Related documents
WL Plastics PE3408 HDPE Pipe – Determining Pressure ...
isco-pipe.comPlastics PE3608/PE3408 HDPE pipe transporting crude oil at 115°F. ()()() PR 37.5 psi 17 1 2 800 0.75 0.50 = − = 3. Determine the long-term pressure rating for 8” IPS DR 9 WL Plastics PE3608/PE3408 HDPE pipe carrying 70°F natural gas in a US Class 3 location. 2 U.S. – Department of Transportation Title 49 Code of Federal