INSTALLATION SHEET - BAK Industries
all the clamps until snug. Then torque an additional 1/2 turn (approx 10 ft/lbs). Repeat steps 2-7 on opposite side. 5 Apply downward pressure to the BAKFlip rail when tightening the clamp to ensure the rail sets fl ush and seals properly. A second set of hands may help. 9 13 Set the cover in the folded position on the BakFlip rails
Download INSTALLATION SHEET - BAK Industries
Information
Domain:
Source:
Link to this page:
Related documents
Tightening Torques - MWRENCH
www.mwrench.com00 00 Extract from company standard BMW N 600 02.0 The maximum tightening torques are: Only applicable to shaft screws with metric standard and fine threads acc. to DIN 13, sheet 13 and nuts with height of 0,8 x d acc. to DIN 934 and only for a µ total = 0.125 (screws phosphatized, screws untreated or galvanized. Lubrication
Bolt Tightening - Tohnichi | Your Torque Partner
www.tohnichi.com（4） Standard tightening torque 40 2-5 Tolerance of Tightening Torque Tolerance of tightening torque 42 2-6 Tightening of Tension Stability ... Tightening torque is not influenced by the bolt length so easy to standardize. The Bolt efficiency will be low due to wide tolerance of the tension. Rotation angle
FASTENERS - RS Components
docs.rs-online.comgreater resistance to vibrations and torque is required. Connecting or coupling nuts are used to provide spacing between component parts of an assembly. Washers Washers are generally used with a machine threaded fastener and nut to spread the load over a greater surface area when tightening a bolt, screw or nut. Sems Screws