JEDEC STANDARD
5.2 Recommended inspection, measuring and test equipment types 5 6 Facilities for ESD protected areas and workstations 6 6.1 Minimum acceptable requirements 6 6.2 ESD item check records 9 6.3 Personnel grounding 9 6.4 Wrist strap and ESD protective footwear resistance path checks 11 6.4.1 Wrist strap resistance measurement path 11
Download JEDEC STANDARD
Information
Domain:
Source:
Link to this page:
Documents from same domain
JEDEC STANDARD - defsup.com
www.defsup.comJEDEC STANDARD Requirements for Handling Electrostatic-Discharge-Sensitive (ESDS) Devices JESD625-A (Revision of EIA-625) DECEMBER …
Related documents
9100 - Lead in Surface Wipe Samples
www.cdc.govLEAD in Surface Wipe Samples: METHOD 9100, Issue 2, dated 15 May 1996 - Page 2 of 2 Include appropriate media and reagent blanks. MEASUREMENT: Depending on detection limit required, use the procedures of NIOSH methods 7082 (Lead by flame AAS) [1], 7300 (Elements by ICP) [2], or 7105 (Lead by graphite furnace AAS) [3], or equivalent methods [6,7].
Common Coating Inspection Practices, Standards & Equipment
cdn.ymaws.com• D 4138 Measurement of Dry Film Thickness of Protective Coating Systems by Destructive Means • D 4214 Degree of Chalking of Exterior Paint Films • D 4263 Indicating Moisture in Concrete by the Plastic Sheet Method • D 4417 Field Measurement of Surface Profile of Blast Cleaned Steel • D 4414 Measurement of Wet Film Thickness of Organic
Measuring and Specifying Pavement Smoothness
www.fhwa.dot.govspikes of the field trace to reduce the variability and expedite the tracing process. The primary purpose of outlining the trace is to average out the spikes and minor deviations due to debris, dirt, rocks, and pavement surface texture. • Position Blankin g Band. The second step is to place the “blanking band” over the profile
GUIDE TO CONE PENETRATION TESTING
cpt-robertson.comof the CPT to geotechnical engineering practice. This guide is a supplement and update to the book ‘CPT in Geotechnical Practice’ by Lunne, Robertson and Powell (1997). This guide is applicable primarily to data obtained using a standard electronic cone with a 60-degree apex angle and either a diameter
Verification and Validation in Computational Fluid Dynamics1
www.southampton.ac.ukthe analysis of surface-water quality and the risk assessment of underground nuclear-waste repositories. These kinds of predictions are beneficial in the development of public policy, in the preparation of safety procedures, and in the determination of legal liability. Thus, because of the
2018 API Catalog final
www.api.orgRecommended practice, for use in conjunction with Ch. 2.7 and Ch. 2.8A. ... • methods used to verify the length of gauge tapes under field conditions and the influence of bob weights and temperature on the gauge tape length, and ... Standard Practice for Level Measurement of Liquid Hydrocarbons in . Petroleum Measurement.
Petroleum Measurement - API
www.api.orgPetroleum Measurement Phone Orders: +1 800 854 7179 (Toll-free: U.S. and Canada) Phone Orders: +1 303 397 7956 (Local and International) 52 This publication is a new entry in this catalog. This publication is related to an API licensing, certification, or accreditation program.
The Rock Quality Designation (RQD) in Practice
web.mst.eduMeasurement of Core Lengths There are various ways to measure the length of a core piccc. The same piece of core could be measured along the centcrlinc, from tip to tip, or along the fully circular barrel section. The recommended procedure is to measure the core length,along thc centerline (Fig. 1). This method