LABORATORY SAFETY DESIGN GUIDE - EHS
non-ionizing radiation (radio -frequency, microwave, ultraviolet, etc.) and large magnetic fields can also be found in Chapter 11 of the Guide. D. Building Requirements 1. Building Occupancy Classification and Control Areas— Occupancy classification and ... contact the UW Radiation Safety Office to determine if this will be required.
Download LABORATORY SAFETY DESIGN GUIDE - EHS
Information
Domain:
Source:
Link to this page:
Documents from same domain
LADDER SAFETY - ehs.washington.edu
www.ehs.washington.eduLight (household) III 200 . ... that may bump you off a ladder. Source: NIOSH Ladder Safety App Source: NIOSH Ladder Safety App . Page 3 of 3 ... • Source: NIOSH Ladder Safety AppKeep area clear near top and bottom of ladder. • Do not use extension ladders in windy or
ACCIDENT PREVENTION PLAN - University of Washington
www.ehs.washington.eduUW Accident Prevention Plan │ Revised July 2019 Page 4 of 21. PURPOSE, SCOPE AND RESPONSIBILITIES PURPOSE This document serves as the University of Washington Accident Prevention Plan (the
GUIDELINES FOR PERSONAL PROTECTIVE EQUIPMENT (PPE)
www.ehs.washington.eduWorking with low hazard chemicals when a low probability of splash exists Skin and eye irritation Fume hood, local exhaust, good general ventilation, enclose process Safety glasses Light chemical resistant gloves Lab coat, closed shoes, long pants, long skirt …
COVID-19 CLEANING AND DISINFECTION PROTOCOL
www.ehs.washington.eduThis protocol reflects requirements and guidelines set forth by the Washington State Department of Labor and Industries, the Centers for Disease Control and Prevention (CDC), and the Washington State Proclamation 20 -12 for Higher Education. Appendix Table 1. at the end of this protocol summarizes the recommended cleaning and
COVID-19 CHEMICAL DISINFECTANT SAFETY INFORMATION
www.ehs.washington.eduRefer to product safety data sheet for hazard communication information. Additional controls and procedures may be necessary when applying products with a mechanical sprayer. This includes garden sprayers, foggers, and ionizing sprayers. Consult with EH&S prior to utilizing mechanical devices to apply disinfectant.
Laser Safety Fundamentals - EHS
www.ehs.washington.edu7.2 Accident Prevention . 7.3 Examples of Laser Accidents . 7.4 Laser Accident Emergency Procedures . 8. References. 8.1 Texts . 8.2 Web Sources . 8.3 Laser Terminology . 8.4 Laser Warning Signs . 8.5 Control Measures for the Seven Laser Classes (ANSI) Acknowledgment . Thanks to Ken Barat for the use of several photographs and diagrams from his
UNIVERSITY OF WASHINGTON COVID-19 FACE COVERING …
www.ehs.washington.eduWhile actively engaged in a performing arts performance. e. University personnel verified to befully vaccinated in accordance with the University’s COVID-19 Vaccination Policy may temporarily remove their face coverings when formally presenting to or instructing a group or class in a large space from behind a podium or in a stage-like setting.
Eating Space Guidance - University of Washington
www.ehs.washington.edueating/drinking space” and detailing expectations for use of the space. Signage should include face covering requirements, hand hygiene , user responsibility for cleaning/disinfe cting high-touch and shared surfaces, and staying home if sick. Include signage that encourages users to …
LITHIUM BATTERY SAFETY - EHS
www.ehs.washington.eduPage 2 of 6 | November 2021 | www.ehs.washington.edu | Lithium-Ion Battery Safety There are four basic cell designs; button/coin cells, polymer/pouch cells, cylindrical cells, and
BIOSAFETY MANUAL - EHS
www.ehs.washington.eduEnvironmental Health and Safety Staff-On-Call Page through 206-685-UWPD WHEN REPORTING A BIOHAZARD EMERGENCY 1. State that this is a Biohazard Emergency 2. Give Your Name 3. Give Your Location (Room and Building) 4. Give the Phone Number You Are Using 5. Describe the Nature of the Emergency 6.
Related documents
Supplier Evaluation Checklist - Sargent Aerospace
www.sargentaerospace.comSUPPLIER EVALUATION CHECKLIST Form 5.382 (20180419) Page 5 5675 West Burlingame Rd. Tucson AZ 85743 Phone: 520.744.1000 Measurement, Analysis and Improvement Compliant Non - …
MAGNETIC MOTOR STARTERS AND MAGNETIC CONTACTORS
sg.mitsubishielectric.comMAGNETIC MOTOR STARTERS AND MAGNETIC CONTACTORS (Note) This mark indicates EC Directive Compliance. ... with the closed contact. Spiral kick-out spring Coil Moving core Stationary core Small-Sized Models S-N10~N35 15mm 15mm 15mm 15mm 15mm 38.5mm Indication of absorber Surge absorber Unified design for N series ... 1.3.1 Non-Reversing …
Standard Guide for Magnetic Particle Testing1
www.aero.ing.unlp.edu.arsafety concerns, if any, associated with its use. It is the ... contact ASTM Customer Service at service@astm.org. For Annual Book of ASTM ... AMS 3040 Magnetic Particles, Non-fluorescent, Dry Method AMS 3041 Magnetic Particles, Non-fluorescent, Wet Method, Oil Vehicle, Ready to Use
CLINICAL EXPERIENCE REQUIREMENTS JANUARY 2019 ...
assets-us-01.kc-usercontent.comMRI Safety Requirements Candidates must demonstrate completion of training and education in the eight areas of MRI safety listed below: • Screening patients, personnel, and non-personnel for MR safe, MR conditional, and unsafe devices and objects • Identify MR safety zones • Static magnetic field (*e.g., translational and rotational forces)
Rosemount 8700 Series - Emerson Electric
www.emerson.comensure the safety of the personnel performing the operations. Refer to the safety messages listed at the beginning of each section before performing any operations. RETURN OF MATERIALS To expedite the return process outside the United States, …
Technical Note: Calibration Verification Practices ...
www.emerson.comsafety, and legal and regulatory requirements when establishing the plant specific procedures. This ... magnetic flowmeter, and the coil windings and coil current are constant if the meter if functioning ... stored in the transmitter’s non-volatile memory that are used when performing the calibration verification.
Characteristics of Food Contact surface materials ...
www.foodprotection.orgNon-magnetic stainless steel The non-magnetic stainless steels, primarily austenitic alloys, are generally Fe-C alloys with Cr (ranging to 26%) and Ni (usually less than 35%). As shown in Table 3, other alloying elements may be used, depending upon the grade. Most of the stainless steel used in the fabrication of food equipment is of
User Manual Non-Contact Infrared Body Thermometer …
www.life-assist.comMS-131002 non-contact infrared body thermometer. A general knowledge of infrared thermometers and an understanding of the features and functions of the thermometer are prerequisites for proper use. The non-contact infrared body thermometer is a medical device designed to last for three years. Please read this manual before using the thermometer.