LC-1 Digital Air/Fuel Ratio (Lambda) Sensor …
- 2 - 1 Overview The LC-1 is a stand-alone Wideband Controller used to measure the Air/Fuel Ratio (AFR) or Lambda for an engine. For gasoline-driven engines, the theoretically optimal air fuel ratio is 14.7 pounds of air for every pound of fuel.
Download LC-1 Digital Air/Fuel Ratio (Lambda) Sensor …
Information
Domain:
Source:
Link to this page:
Documents from same domain
LC-2 Digital Air/Fuel Ratio (Lambda) Sensor …
www.innovatemotorsports.com3 2 Mounting and Wiring the LC-2 2.1 Mounting The LC-2 controller body should be mounted inside the cabin or in another dry, protected location away from the elements.
PSN-1 User Manual - innovatemotorsports.com
www.innovatemotorsports.com2 1. PSN-1 The PSN-1 is an all-in-one, PowerSafe override, wideband air/fuel ratio and Nitrous Bottle Pressure gauge with RPM window switch. Using the
LM-1 Manual 3.4 - innovatemotorsports.com
www.innovatemotorsports.comLM-1_Manual_3.4.doc LM-1 Digital Air/Fuel Ratio (Lambda) Meter Manual Warning! The Oxygen Sensor used in this device gets very hot in operation.
MTX-L Digital Air/Fuel Ratio Gauge User Manual
www.innovatemotorsports.com8 2.4.1 Calibration Schedule Normally aspirated (daily driver) - Calibrate before installation of new sensor - Calibrate new sensor again after 3 month of use
LM2 Manual 1.3 - innovatemotorsports.com
www.innovatemotorsports.comDocument # 31-0008 LM2_Manual_1.3.doc 4 Top Bottom SD Memory Card Slot USB Connector Sensor Input # 2 (Enabled with the Dual Channel version) Analog Cable
11-0159A MTX-L PLUS
www.innovatemotorsports.comThe MTX-L PLUS is an integrated gauge and controller for wideband AFR (lambda) measurements. Although it can be operated stand alone, it has digital I/O for integration with other MTS compatible products and a configurable analog output for integration with ECU’s and 3rd party data loggers.
Digital Air/Fuel Ratio Meter User Manual
www.innovatemotorsports.comDigital Air/Fuel Ratio Meter User Manual This manual assumes that firmware version 1.18 or later is installed. Warning! It is extremely important to avoid hot-plugging sensor connections. Do not connect or disconnect the sensor connectors while the unit is powered ON. The Oxygen Sensor used in this device gets very hot in operation.
Related documents
AutoVE Tuning Tutorial for LS1 Controllers - EFILive
download.efilive.comAndy Reyna (TAQuickness) & David Christie (Tre-Cool) AutoVE Tuning Tutorial for LS1 Controllers
LC-2 Digital Air/Fuel Ratio (Lambda) Sensor …
www.innovatemotorsports.com3 2 Mounting and Wiring the LC-2 2.1 Mounting The LC-2 controller body should be mounted inside the cabin or in another dry, protected location away from the elements.