Mopar Performance Electronic Ignition Kit Instructions
3. Note the location of the number one spark plug wire on the distributor. Disconnect the spark plug wires from the spark plugs and coil. Remove the wires from any wire looms or retainers. 4. Disconnect the distributor cap hold down clips, remove the distributor cap and spark plug wires together. Set them aside. 5.
Download Mopar Performance Electronic Ignition Kit Instructions
Information
Domain:
Source:
Link to this page:
Related documents
Tubular Gas Fired Direct Spark Propeller Unit Heaters
www.trane.comT = Single Stage, Direct Spark Ignition V = Two Stage, Direct Spark Ignition (Size 006-120 only) Digit 10 - Design Sequence B = Second design Digit 11 - Heat Exchanger Material 1 = Standard (Aluminized Steel) 2 = 409 Stainless Steel Digits 12,13,14 0 Digit 15 - Miscellaneous 0= None B = Air Pressure Switch for Above 5000 Feet
DYNA S ELECTRONIC IGNITION INSTALLATION …
www.wwag.com9. Route the cable from the ignition assembly out the hole in the engine case and over to the ignition coils. being careful to avoid the exhaust system. 1 0. Crimp the connectors supplied with the kit on to the ignition wires. -.. . 11. One end of the primary of each coil should be connected together with the supplied jumper.