No Start After Replacing Ford PCM
Certain Ford vehicles incorporate the Passive Anti-Theft System (PATS). This security feature immobilizes the vehicle by disabling the fuel pump, injectors and possibly the starter, until the ignition key relearn is performed on the car. Motorcraft Service provides a reference chart that identifies all Ford PATS vehicles.
Download No Start After Replacing Ford PCM
Information
Domain:
Source:
Link to this page:
Documents from same domain
GM Vehicle Theft Deterrent (VTD) Relearn …
my.cardone.comJDB2010 PT 77-0011 GM vehicles have three types of Vehicle Thief Deterrent (VTD) systems, each requiring their own
ENGINE CONTROL COMPUTER BASICS - CARDONE
my.cardone.comJD 8051 PT 77-0002 ENGINE CONTROL COMPUTER BASICS INPUTS A/C Compressor Clutch Signal Detonation Sensor Oxygen Sensor A/C …
What is Variable Assisted Power Steering, What is …
my.cardone.comJDA6135 PT 20-0024 What is Variable Assisted Power Steering, What is EVO? EVO means Electronic Variable Orifice.
Ford Passive Anti-Theft System Relearn Procedures
my.cardone.comThe document includes a vehicle-to-PATS cross-reference chart, an ignition key identification photo-guide, a list of PATS DTC descriptions, and many PATS hints, tips, and relearns procedures.
Nissan Optical Distributor Test
my.cardone.comMost Nissan vehicles, 1984 & newer, equipped with optical disc sensor distributors. Engine turns over, but does not start. Many Nissan vehicles have a power transistor controlling the coil (or igniter).
Tips To Prevent CV Axle From Getting Stuck in Transmission
my.cardone.comDSA7207 PT 60-0010 Tips To Prevent CV Axle From Getting Stuck in Transmission All Front Wheel Drive Vehicles With CV Axles. Inability to remove inner CV axle joint from transmission.
BODY CONTROL COMPONENT - CARDONE
my.cardone.comBODY CONTROL COMPONENT READ THIS FIRST: • Find out what damaged the original Body Control Component (BCC). Fix whatever caused the damage. • Do not remove the replacement BCC unit from its shipping carton until
Ford Module Programming (FMP) Purchase and Installation …
my.cardone.comFord “PATS” Reprogramming Guide Section C3 Page 1 of 4 Subject: Ford PATS Reprogramming Doc. # C3 NOTE: • This guide shows the common steps in Passive Anti-Theft System (PATS) programming. Variations to this procedure are application-specific. Follow the screen
Ford Passive Anti-Theft System Relearn Procedures
my.cardone.comPassive Anti-Theft Systems (PATS), also called Ford Securilock, is a vehicle security feature introduced on 1996 and later Ford vehicles. When replacing the Powertrain Control Module (PCM) on a PATS-equipped vehicle, a parameter reset or relearn procedure must be performed after the PCM is installed.
GM Vehicle Theft Deterrent (VTD) Relearn Procedures
my.cardone.comIf the key signature transmitted is acceptable to the theft deterrent control module, the theft deterrent control module will transmit fuel enable password to the PCM. If the fuel enable password is correct, the PCM will start the vehicle. To perform a relearn on a Passkey III system, make sure there is a fully charged battery in the vehicle.