OPERATING INSTRUCTIONS
2 SAFETY PRECAUTIONS WARNING CAUTION • Since rotating parts and parts which could cause an electric shock are used in this product, be sure to read these “Safety Precautions” before use. • Since the cautionary items shown here are important for safety, be sure to observe them. Marks and their meanings are as shown below. Incorrect handling could cause a serious …
Download OPERATING INSTRUCTIONS
Information
Domain:
Source:
Link to this page:
Documents from same domain
MODEL PUMY-P112-140VKM1 (-BS) PUMY ... - …
www.mitsubishi-les.info2 S MEE14K038 1. SPECIFICATIONS OUTDOOR I.S SERIES1. SPECIFICATIONS Model PUMY-P112VKM1(-BS) PUMY-P125VKM1(-BS) Power source 1-phase 220-240V 50Hz 1-phase 220-240V 50Hz
MODEL PURY-P200-500YNW-A (-BS) PURY-EP200 …
www.mitsubishi-les.infoDetails on foundation work, duct work, insulation work, electri-cal wiring, power source switch, and other items shall be re-ferred to the Installation Manual. Due to continuing improvement, above specifications may be subject to change without notice. Notes: Unit converter 1.Nominal cooling conditions (subject to JIS B8615-2)
MODEL PEFY-M-VMA(L)-A
www.mitsubishi-les.infoRemarks * Details on foundation work, duct work, insulation work, electrical wiring, power source switch, and other items shall be referred to the Installation Manual. * Due to continuing improvement, above specifications may be subject to change without notice. Notes: Unit converter 1.Nominal cooling conditions
Air Conditioning Control System Centralized Controller AE …
www.mitsubishi-les.infoSet the IP address of the PC to be used for the BACnet® Setting Tool. Set an IP address for the PC that does not duplicate the IP address of LAN1 of each AE-200 (initial value: 192.168.1.1) but is an IP address of the same network. For example, when the IP address of LAN1 of the AE-200 is the default value [192.168.1.1] and the subnet mask
Related documents
SoClean.com User Manual - ZiftrShop
cdn.ziftrshop.comWARNING: Ensure the correct Clock time and Cycle Start time are set on your SoClean 2 before using your equipment. Pay particular attention to the AM/ PM setting if using 12-hr mode. Failure to do so may result in the SoClean 2 device operating at an unexpected time. WARNING: In the event of loss of power to your
Safety Data Sheet: Aluminum Alloys - Wolverine Industries
www.wlv.comSignal Word, Hazard Statements & Symbols: WARNING Symbols Hazard GHS Classification Hazard Statements Flammable Solid Category – 1 Flammable Solid (in chips or powder form) STOT (single exposure) Category – 1 May cause respiratory and skin irritation. N/A Eye Irritation Category –2B Causes eye irritations. Notes: