Product Data Sheet - Castrol
Aircol SR range is fully compatible with nitrile, silicone, polyurethane and fluropolymer seal materials typically used in compressor units. It is not compatible with butadiene styrene (SBR) or ethylene propylene (EPDM) seals. Aircol SR is classified as follows: DIN 51506 classification - VDL ISO 6743/3 - DAG, DAH and DAJ for rotary air compressors
Download Product Data Sheet - Castrol
Information
Domain:
Source:
Link to this page:
Related documents
Aircol SN Range - Castrol
msdspds.castrol.comUnder these conditions Aircol SN compressor oils offer reduced carbon forming tendencies and extended) Tj 9 0 0 9 56.25 473.25 Tm 0.01197 Tc (oil life when compared to mineral oils due to their much higher oxidation resistance. In reciprocating units, Aircol SN) Tj 9 …
Castrol Aircol SR 46
msdspds.castrol.comCastrol Aircol SR 46 meets the physical and performance specifications of major compressor manufacturers including Atlas Copco, Compair, Champion, Sullair, Ingersoll Rand and more. Typical Characteristics Castrol Aircol SR 46 ISO Viscosity Grade 46 Density @ 15°C 0.836 Kinematic Viscosity, cSt @ 40°C @ 100°C 46.0 7.85 Viscosity Index 137
Product Data - Castrol
msdspds.castrol.comCastrol Aircol PD oils are a range of compressor lubricants, based upon highly refined mineral oils, which are intended for the lubrication of both reciprocating and rotary air compressors. Application Aircol PD grades are ashless oils recommended for the lubrication of rotors, bearings and gears in rotary compressors,
Aircol 266 & 299 - Castrol
msdspds.castrol.comAircol 266 & 299 are specifically for use in refrigeration and air conditioning plants using fluorocarbon refrigerants. The exceptional low temperature characteristics of these oils prevent the flocculent precipitation of wax which can otherwise occur in high performance plant using Freon refrigerants.
Aircol CM Range - Castrol
msdspds.castrol.comHowever as a general guide Aircol CM 32 and 46 are suitable for oil flooded rotary compressors, whereas Aircol CM 68, CM 100 and 150 would be selected for lubricating the crankcase and cylinders of reciprocating compressors. Aircol CM 150 is also recommended for sliding-vane compressors, or for reciprocating units at high ambient temperatures.
Aircol SW Range - Castrol
msdspds.castrol.comThe synthetic base stocks used in the Aircol SW range are fully miscible with HFCs, in particular R134a, even at temperatures well below the minimum likely to be encountered in service. The Aircol SW grades have been formulated to enhance hydrolytic stability, load carrying and inhibition against copper plating.
Synthetic rotary compressor lubricant - The Lubrication Store
www.thelubricationstore.comAircol SR range is fully compatible with nitrile, silicone, polyurethane and fluropolymer seal materials typically used in compressor units. It is not compatible with butadiene styrene (SBR) or ethylene propylene (EPDM) seals. Aircol SR is classified as follows: DIN 51506 classification - VDL ISO 6743/3 - DAG, DAH and DAJ for rotary air compressors