Rigid Sheet Specifications
series stainless steel on galvanized steel. D. Aluminum top caps, inside corners, divider bars shall be extruded from 6063-T5 aluminum. 2.05 FINISHES A. Color or pattern of Palladium® Rigid Vinyl Sheet to be selected by the architect from the Palladium® Rigid Vinyl Sheet finish selection. Surface shall have a velvet texture.
Download Rigid Sheet Specifications
Information
Domain:
Source:
Link to this page:
Documents from same domain
Tape-On
www.inprocorp.com7. Color Consistency: Provide components matched in accordance with SAE J-1545 - (Delta E) with a color difference no greater than 1.0 units using CIE Lab, CIE CMC, CIE LCh, Hunter Lab or similar color space scale systems. 1.05 SUBMITTALS A. Product Data: Manufacturer's printed product data for each type of corner guard specified.
Important
www.inprocorp.comcolor match caulk (optional) inpro #333 extension roller palladium® rigid sheet inpro bond, xt-2000+, or 3m fastbond 30 inpro #545 trowel 407 top cap 407a optional aluminum top cap 409 inside corner 409a optional aluminum inside corner 408 vertical divider 408a optional aluminum vertical divider tape-on corner guard 420a optional aluminum ...
Related documents
HVAC Control & Balancing Dampers - Greenheck-USA
content.greenheck.comRigid frame - The joint has an equivalent thickness of 10 ga. (3.5mm) steel. Increased corrosion resistance - The Tog-L-Loc process does not use heat, so Greenheck damper frames have greater corrosion resistance by retaining the galvanized coating. Square frame for easier install - Using four separate frame components (top,
With and without mounting lugs for threaded rigid and IMC ...
www.eaton.comWith and without mounting lugs for threaded rigid and IMC conduit FS two-gang tandemA FSC two-gang tandemA FS/FD two-gang FSC/FDC two-gang FSE two-gang Dimensions (in inches): Two-gang tandem Two-gang Two-gang tandem Two-gang Ordering information: AUse single-gang covers only. BAvailable in copper-free aluminum. To order, add suffix ‘SA’ to ...
MASTER SPECIFICATIONS Division 09 FINISHES
www.northwestern.edu2. Protective Coating: ASTM A 653/A 653M, G60 (Z180), hot-dip galvanized unless otherwise indicated. C. Studs and Runners: ASTMC 645.[Use either steel studs and runners or embossed steel studs and runners.] 1. Steel Studs and Runners: a. Manufacturers: Subject to compliance with requirements, provide products by one of the following: