STANDARD OPERATING PROCEDURE - OMMSWCC
spanner to the break out wrench and connect the other end to the wire sleeve of the drill. Open the break out wrench. Bit should get loosened by two/three pitch. If the chain spanner slips at the grip then tighten the adjusting bolt of the chain spanner and/or give a packing .Give reverse rotation to the rotary The bit will open.
Download STANDARD OPERATING PROCEDURE - OMMSWCC
Information
Domain:
Source:
Link to this page:
Documents from same domain
STANDARD OPERATING PROCEDURE
www.ommswcc.orgSTANDARD OPERATING PROCEDURE FORM NO.HSE/CORP/4 ACTIVITY Excavation SITE SMC DEPARTMENT Mining SOP NO. IMFA/SOP/SMC/MINING/08 REVISION 00 EFF DATE: 19.6.14 NO. OF PAGES Page11 iv)Slip/Fall v)Vision problem vi)Strike to persons near by iv)Any spilled/ leaked oil is cleaned by cotton waste. v)Keep the cab. window clean so as to
Related documents
STANDARD SERIES Badger 5 - InSinkErator
insinkerator.emerson.comSelf-service wrench. Available with or without a factory installed power cord. Warranty: 3-Year parts and in-home service. Sample Specification The complete InSinkErator warranty is included in the Care & Use Booklet packed with each uni.t * ... STANDARD SERIES FoodWaste Disposers
CAP SCREW HEAD WRENCH SIZE CHART - Imperial Supplies
www.imperialsupplies.comPhone: 1-800-558-2808. imperialsupplies.com. CAP SCREW HEAD WRENCH SIZE CHART. Imperial has made a concerted effort to provide accurate information in its catalog and on its web site, however Imperial assumes no responsibility for the accuracy of the information.
National Standard Taper Pipe (NPT) Threads Size Chart
www.pyromation.comNational Standard Taper Pipe (NPT) Threads Size Chart 1/16 0.3125 27 0.16 0.2611 1/8 0.405 27 0.18 4½ 2½ 0.26 1/4 0.54 18 0.2 4 3 0.401 ... Wrench makeup turns Length of. effective thread Nominal size (inside diameter) Length of engagement (tightened by hand) Actual OD Threads per inch Hand tight turns.
Standard Operating Procedures of Hand Tools
www.tri-c.eduStandard Operating Procedures of Hand Tools Introduction To safely use each tool in Ideation Station, follow the standard operating procedures below. Every hand tool in Ideation Station is listed and described in this document. If you are unsure ... Box Wrench Page 42. Spud Wrench Page 43. Adjustable Wrench Page 44. Socket Wrench
Torque Range - Snap-on
www1.snapon.com1994 and was calibrated on a torque standard traceable to the National Institute of Standards Technology (NIST). • Accuracy. All QD Series Torque Instruments are accurate to ±4% clockwise and ±6% counterclockwise from 20% of full scale to full scale. • Long Life Ratchet Head.QD Series Torque Instruments feature the Snap-on®