U.S. Technical Guide
4 LVL 2900Fb-2.0E Product Specifications & Design Values NOTES: 1. The Allowable Moment and Shear capacities are for normal load duration and shall be adjusted according to code. 2. The tabulated Allowable Moment capacities assume continuous lateral support of the compression edge.
Download U.S. Technical Guide
Information
Domain:
Source:
Link to this page:
Documents from same domain
Wall Framing Technical Guide - Engineered Wood Products
lpcorp.comWall Framing Technical Guide 1730F b-1.35E, 2360F b-1.55E and 2500F b-1.75E LSL 2250F ... (prescriptive) and engineered wood-frame wall construction. PRESCRIPTIVE CONSTRUCTION Prescriptive construction provisions for wood-framed walls ... In this guide, the user needs only to select the appropriate ...
LP SolidStart I-Joists Technical Guide for Residential ...
lpcorp.comPlease verify availability with the LP SolidStart Engineered Wood Products distributor in your area prior to specifying these products. LP SolidStart I-Joists Technical Guide for Residential Construction LPI ... Flange Bearing Resistance and that of a wood support will increase with additional bearing length.
Design No. U348 BXUV.U348 Fire-resistance Ratings - ANSI ...
lpcorp.comFire resistance assemblies and products are developed by the design submitter and have been investigated by UL for compliance with applicable requirements. The published information cannot always address every construction nuance encountered in the field. ... density of 0.9 pcf (min R-13 thermal insulation rating), pressure fit in the wall ...
LP SolidStart LSL & LVL Wall Framing Technical Guide
lpcorp.comin direct contact or are used as wall studs spaced no more than 24" oc and properly connected together by an adequate wall sheathing. 7. The allowable Tension, F t, for LP SolidStart LSL is assigned for a standard length of 3 feet. For lengths longer than 3 feet, multiply F
Related documents
ICC-ES Evaluation Report ESR-3223 - ITW BUILDEX
www.itwbuildex.com2006 IBC). Nominal and allowable fastener tension and shear strengths for the screws are shown in Table 4. Allowable connection capacities for use in Allowable Strength Design (ASD), for pull-out, pull-over, and shear (bearing), are provided in Tables 2, 3 and 5, respectively, based upon laboratory testing. Instructions on how to
Chapter 2. Design of Beams – Flexure and Shear
www.egr.msu.eduThe following values of deflection are typical maximum allowable total (service dead load plus service live load) deflections. − Plastered floor construction – L/360 − Unplastered floor construction – L/240 − Unplastered roof construction – L/180
POWER DENSITY - University of Hawaiʻi
www.phys.hawaii.eduallowable and that either better limiter circuitry may be required in the missile or a new location is needed for the missile or jammer. Of course if the antenna efficiency is 0.23 or less, then the power will not damage the missile's receiver. If the missile gain were known to be 25 dB, then a more accurate calculation could be performed.