UPDATED PHLEBOTOMY PROCEDURES
CLSI ORDER OF DRAW •YELLOW SPS (Blood Cultures) •LT.BLUE Sodium Citrate •PLAIN RED No Additive •PLASTIC RED Clot Activator •GOLD, RED/GRAY SST/Gel w/ Clot Activator •GREEN Heparin-Lithium or Sodium •LAVENDER, TALL PINK EDTA PURPLE EDTA •GRAY Sodium Fluoride, Potassium Oxalate •NOTE: Other tubes will be added into the Order of Draw …
Download UPDATED PHLEBOTOMY PROCEDURES
Information
Domain:
Source:
Link to this page:
Related documents
Lab Biosafety Guidelines: Handling and Processing ...
clinlab.ucsf.edu•Wear a lab coat in the lab, & remove before exiting. Consider it dirty. •Wear gloves when handling specimens. Change if torn/damaged. Consider gloves dirty. •Be aware of hand motions and what you touch •Treat every sample as if it is infectious •If risk of splash (eg uncapping samples, pour-offs, minimal
Laboratory Safety - University of Washington
faculty.washington.eduThe lab coat should be worn only in the lab to protect your clothing. When you are finished with the lab, remove the coat before leaving the room to prevent spreading contamination outside the laboratory. Gloves will be provided to prevent contact of chemical or biological agents with your hands. There are a
BIOCHEMISTRY LAB MANUAL - Komar University of Science …
komar.edu.iq- Remove any protective equipment (i.e., gloves, lab coat or apron, chemical splash goggles) before leaving the laboratory. Biochemistry Lab (CHM2415C) MLS 6 Emergency Procedure - Know the location of all the exits in the laboratory and building. - Know the location of the emergency phone. ...
LAB COAT SIZE CHARTS - Vanderbilt University
nursing.vanderbilt.eduLAB COAT SIZE CHARTS SIZE CHARTS MISSES’ SIZING - AVERAGE HEIGHT 5’4”-5’7” Order size according to the largest of your bust, waist or hip measurements. MEN’S SIZING - AVERAGE HEIGHT 5’8”-6’0” *Coats, Blazers: Give regular coat size or chest measurement. If your size falls in between, order the larger size. 180054_0617
Guidance for the Selection of Laboratory Coats
ors.od.nih.govlaboratory coat material when working with the hazards that correspond to the applicable hazard or hazard surrogate tested. These testing methods only test the material and do not test the complete laboratory coat making it important to consider characteristics of the laboratory coat such as seams, stitches and where the
Introduction to Anatomy & Physiology
www.austincc.edua. Apron or Lab Coat – You may be instructed to wear an apron or lab coat over your clothes when handling biohazards or hazardous chemicals. b. Wear natural fiber clothing for any lab activity involving open flame (synthetic material melts onto skin in a fire). c. Before putting on gloves remove watches, rings, and bracelets that could either
Microbiology Lab Safety - University of Minnesota Duluth
www.d.umn.edu1. Wear a lab coat, disposable gloves, safety glasses or a face shield, and if needed, approved respiratory equipment. 2. Soak a paper towel(s) in an appropriate disinfectant (70% ethanol or fresh 10% bleach solution) and place around the spill area. 3. Working from the outer edges into the center, clean the spill area with fresh towels soaked ...
Lab Safety Guideline: Sodium Azide - Harvard University
www.ehs.harvard.eduo Lab coat, long pants, and closed toed shoes. o Chemical protective goggles. o Work behind sash. o Nitrile gloves provide adequate protection (at least 0.11mm [4 mils]) thickness. Change gloves frequently. Wash hands thoroughly each time gloves are removed. • Keep all containers tightly closed when not in use and during transport.