Supercapacitors FC Series - Farnell

1 1 KEMET Electronics Corporation Box 5928 Greenville, SC 29606 864-963-6300 S6011_FC 3/29/2017 One world. One KEMETB enefits Surface mount without holder Wide range of temperature from 25 C to +70 C Maintenance free Operational Voltage: VDC Highly reliable against liquid leakage Lead-free and RoHS CompliantOverviewFC Series Supercapacitors , also known as Electric Double-Layer Capacitors (EDLCs), are surface mount type components intended for high energy storage applications. The FC Series is designed specifically for reflow soldering, allowing them to be attached to a printed circuit board (PCB) have characteristics ranging from traditional capacitors and batteries.

2 As a result, Supercapacitors can be used like a secondary battery when applied in a DC circuit. These devices are best suited for use in low voltage DC hold-up applications such as embedded microprocessor systems with flash SeriesPart Number SystemFC0H104 ZFTBR24 SSSeries Surface MountMaximum Operating VoltageCapacitance Code (F)Capacitance ToleranceEnvironmentalTape TypeOrientationTape WidthC-SpecFCS FC0V = VDC 0H = VDCF irst two digits represent significant figures. Third digit specifies number of = 20/+80%F = Lead-freeTB = EmbossedR = Positive electrode forward24 = 24 mm 32 = 32 mm 44 = 44 mm SS = 3 digit serial number marked on top Blank = No serial number marking2 KEMET Electronics Corporation Box 5928 Greenville, SC 29606 864-963-6300 S6011_FC 3/29/2017 Supercapacitors FC SeriesDimensions Millimeters D (+ )FC0H104ZF (+ ) (+ )FC0H474 ZFTBR32 (+ )FC0H105 ZFTBR44 (+ )FC0V104ZF (+ ) (+ )FC0V474ZF TBR (+ ) (+ )FCS0H104ZF (+ ) (+ )FCS0V104ZF (+ ) (+ )FCS0V474ZF TBR (+ )

3 3 KEMET Electronics Corporation Box 5928 Greenville, SC 29606 864-963-6300 S6011_FC 3/29/2017 Supercapacitors FC SeriesPerformance CharacteristicsSupercapacitors should not be used for applications such as ripple absorption because of their high internal resistance (several hundred m to a hundred ) compared to aluminum electrolytic capacitors. Thus, its main use would be similar to that of secondary battery such as power back-up in DC circuit. The following list shows the characteristics of Supercapacitors as compared to aluminum electrolytic capacitors for power back-up and secondary BatteryCapacitorNiCdLithium IonAluminum ElectrolyticSupercapacitorBack-up ability Eco-hazardCd Operating Temperature Range 20 to +60 C 20 to +50 C 55 to +105 C 40 to +85 C (FR, FT)Charge Timefew hoursfew hoursfew secondsfew secondsCharge/Discharge Life Timeapproximately 500 timesapproximately 500 to 1,000 timeslimitless (*1)limitless (*1)Restrictions on Charge/DischargeyesyesnonenoneFlow Solderingnot applicablenot applicableapplicableapplicableAutomatic Mountingnot applicablenot applicableapplicableapplicable (FM and FC Series )

4 Safety Risksleakage, explosionleakage, combustion, explosion, ignitionheat-up, explosiongas emission (*2)(*1) Aluminum electrolytic capacitors and Supercapacitors have limited lifetime. However, when used under proper conditions, both can operate within a predetermined lifetime.(*2) There is no harm as it is a mere leak of water vapor which transitioned from water contained in the electrolyte (diluted sulfuric acid). However, application of abnormal voltage surge exceeding maximum operating voltage may result in leakage and ApplicationsIntended Use (Guideline) Power Supply (Guideline)ApplicationExamples of EquipmentSeriesLong time back-up500 A and belowCMOS microcomputer, IC for clocksCMOS microcomputer,static RAM/DTS(digital tuning system)FC seriesEnvironmental ComplianceAll KEMET Supercapacitors are RoHS Compliant4 KEMET Electronics Corporation Box 5928 Greenville, SC 29606 864-963-6300 S6011_FC 3/29/2017 Supercapacitors FC SeriesTable 1 Ratings & Part Number ReferencePart NumberMaximum Operating Voltage (VDC)Nominal Capacitance Discharge System (F)

5 Maximum ESR at 1 kHz ( )Maximum Current at 30 Minutes (mA)Voltage Holding Characteristic Minimum (V)Weight (g)FC0V104ZF TBR numbers in bold type represent popularly purchased PatternBABCLogoLand PatternLead TerminalDiameter (mm) KEMET Electronics Corporation Box 5928 Greenville, SC 29606 864-963-6300 S6011_FC 3/29/2017 Supercapacitors FC SeriesFC TypeFCS TypeTemperature on theCapacitor Top ( C)250200150100500 Time (seconds)Tp Time exceeding 200 C120 seconds160 CReflow ProfilePeak temperaturePeak Temperature: 235 C, within 10 secondsPeak Temperature ( C)250240230220210200Tp (seconds)Tp Time Exceeding 200 C0102030405060 Reflow Profile050100150200250300050100150200250 300350400 Time (seconds)Temperature ( C)200 C150 C260 CTemperature on theCapacitor Top217 C150seconds70 secondsAbove "Reflow Profile" graph indicates temperature at the terminals and capacitor for Use This Series is exclusively for reflow soldering.

6 It is designed for thermal conduction system such as combination use of infrared ray and heat blow. Consult with KEMET before applying other methods. The reflow condition must be kept within reflow profile graphs shown below. Applying reflow soldering is limited to 2 times. After the first reflow, cool down the capacitor thoroughly to 5 35 C before the second consult with KEMET when applying reflow soldering in a more severe condition than the condition described "Reflow Profile" graph indicates temperature at the terminals and capacitor TemperatureBelow +260 COver +255 CWithin 10 secondsOver +230 CWithin 45 secondsOver +220 CWithin 60 secondsOver +217 CWithin 70 secondsTime between +150 C to +200 C (temperature zone over +170 C within 50 seconds)

7 15 0 seconds6 KEMET Electronics Corporation Box 5928 Greenville, SC 29606 864-963-6300 S6011_FC 3/29/2017 Supercapacitors FC SeriesSpecifications* Must fulfill the above condition after reflow soldering. ItemFC V Type, V TypeTest Conditions (conforming to JIS C 5160-1)Category Temperature Range 25 C to +70 CMaximum Operating VDC, VDCC apacitanceRefer to Table 1 Refer to Measurement Conditions Capacitance Allowance+80%, 20%Refer to Measurement Conditions ESRR efer to Table 1 Measured at 1 kHz, 10 mA; See also Measurement Conditions Current (30 minutes value)Refer to Table 1 Refer to Measurement Conditions * SurgeCapacitance> 90% of initial ratingsSurge voltage:Charge:Discharge:Number of cycles: Series resistance:Discharge resistance: V ( V type, V type) V ( V type)30 seconds9 minutes 30 seconds1, F, F 300 F 240 F 150 F 56 F 30 F 15 0 70 2 CESR 120% of initial ratingsCurrent (30 minutes value) 120% of initial ratingsAppearanceNo obvious abnormality* Characteristics in Different TemperatureCapacitancePhase 2 50% of initial valueConforms to 1:Phase 2:Phase 4:Phase 5:Phase 6.

8 +25 2 C 25 2 C+25 2 C+70 2 C+25 2 CESR 400% of initial valueCapacitancePhase 3 ESRC apacitancePhase 5 200% of initial valueESRS atisfy initial ratingsCurrent (30 minutes value) CV (mA) or belowCapacitancePhase 6 Within 20% of initial valueESRS atisfy initial ratingsCurrent (30 minutes value)Satisfy initial ratings* Vibration ResistanceCapacitanceSatisfy initial ratingsConforms to : Testing Time: 10 to 55 Hz6 hoursESRC urrent (30 minutes value)AppearanceNo obvious abnormality* Solder Heat ResistanceCapacitanceSatisfy initial ratingsCooled down to ambient temperature after reflow soldering, then the product must fulfill the condition stated left. (See Precautions for Use)ESRC urrent (30 minutes value)AppearanceNo obvious abnormality* Temperature CycleCapacitanceSatisfy initial ratingsConforms to Condition:Number of cycles: 25 C Room temperature +70 C Room temperature5 cyclesESRC urrent (30 minutes value)AppearanceNo obvious abnormality7 KEMET Electronics Corporation Box 5928 Greenville, SC 29606 864-963-6300 S6011_FC 3/29/2017 Supercapacitors FC SeriesSpecifications cont d* Must fulfill the above condition after reflow soldering.

9 VoltageDate CodePolarity(negative)FC VoltageSerial NumberPolarity(negative) Series NameLogoN TDate SNominalCapacitanceMaximumOperating VoltageDate CodeFCS TypePolarity(negative)D = mmD = 16 & 21 mmD = mmDisplays nominal capacitance, maximum operating voltage serial number, polarity, V Type, V TypeTest Conditions (conforming to JIS C 5160-1)* High Temperature and High Humidity ResistanceCapacitanceWithin 20% of initial valueConforms to : Relative humidity: Testing time: +40 2 C90 to 95% RH240 8 hoursESR 120% of initial ratingsCurrent (30 minutes value) 120% of initial ratingsAppearanceNo obvious abnormality* High Temperature LoadCapacitanceWithin 30% of initial valueConforms to applied: Series protection resistance: Testing time: Maximum operating voltage0 1,000+48 (+48/ 0) hoursESR< 200% of initial ratingsCurrent (30 minutes value)< 200% of initial ratingsAppearanceNo obvious abnormality* Self Discharge Characteristics (Voltage Holding Characteristics) V type: Voltage between terminal leads > VCharging conditionVoltage applied: Series resistance: Charging time: VDC (Terminal at the case side must be negative)0 24 V type.

10 Not specifiedStorageLet stand for 24 hours in condition described below with terminals temperature: Relative humidity:< 25 C< 70% RH8 KEMET Electronics Corporation Box 5928 Greenville, SC 29606 864-963-6300 S6011_FC 3/29/2017 Supercapacitors FC SeriesTape & Reel Packaging Information MillimetersBWACEDR:10tMarkTBR24 TBR32 TBR44A380 2330 2380 2 BProduct height mm80 1100 1100 1 Product height mm100 1C13 height height KEMET Electronics Corporation Box 5928 Greenville, SC 29606 864-963-6300 S6011_FC 3/29/2017 Supercapacitors FC SeriesTape & Reel Packaging Information Millimeters cont'dt1 Super capacitors fittingon square-holeSuper capacitors fittingon square-holet2t1t2 ABP2P0 FEWF orward directionSprocket holeIndented square-holefor fitting super D0P1P2P0P1 height height Pack Packaging InformationPart NumberQuantity per ReelFC0H473 ZFTBR241,000 pieces/reelFC0H104ZF TBR241.