Hi Gloss Metal Polyurethane - Asian Paints

1 Product Information Sheet PC 2203 Page 1 of 2Hi Gloss Metal PolyurethaneTwo component, air drying, acrylic aliphatic Polyurethane coatingFeatures* Excellent finish with high Gloss * Excellent color & Gloss retention* Excellent outdoor durability* Excellent flow & leveling characteristics* Tough, abrasion resistant coatings* Good resistance to chemicals & polluted environmentsTechnical DataGloss:GlossyVolume solids:Approx. 40 - 45% (depending on shades)Recommended DFT / Coat:30 - 35 micronsTheoretical covering - m2/ l @ 30 micronsDrying time at 30 C:Surface dry-30 minutes:Hard dry-16 hours:Full cure-7 daysOvercoating interval at 30 C:Min.:8 hours:Max.:Unlimited, provided surface is dryand clean from all contaminationShelf life (cool & dry place):At least 12 monthsFlash point:Base-not less than 24 C:Hardener-not less than 24 CDirections for useSurface Preparation & Substrate Conditions- Suitable epoxy primer, epoxy / Polyurethane undercoat; dry & free from all surface contamination.

2 In caseof aged epoxy coating, the surface should be sufficiently roughened prior to Substrate temperature should be at least 3 C above dew point but not above 50 the base and hardener separately. If settling is observed in the base, loosen the settled material withthe help of hand stirrer followed by power driven stirrer for quick homogenous mixing. Mix hardenergradually into the base under continuous stirring as follows:Mixing Ratio:Base : Hardener(By volume)4: 1 Induction time:15 minutesPot life at 30 C :4 hoursNote: In case of part mixing (which should be avoided) close the container lids tightly to avoid contact withatmospheric the best of our knowledge the information provided herein is true and accurate at the date of issuance. Since we have no control over the quality or condition ofthe substrate or the various factors affecting the use and application of the product, we do not accept any responsibility or liability arising out of use of the company reserves the right to modify data contained herein without prior notice.

3 Any change in data would normally be followed by issue of a new data user should check with the nearest sales office of the company and confirm the validity of the information, prior to using the Information Sheet PC 2203 Page 2 of 2 Issue Date: November 2003 Regd office : Asian Paints (I) Ltd., 6 A Shantinagar, Santacruz(east) Mumbai 400 055. Tel : (022)-56958000 Fax : (022)-56958888 email: web: / RollerRecommended thinner:T - 213 Volume of thinner:0 - 5 %Air SprayRecommended thinner:T - 213 Volume of thinner:10 - 25 %Nozzle - mmNozzle Pressure: - MPa (approx. 3-4 atm; 43-57 )Airless SprayRecommended thinner:T - 213 Volume of thinner:0 -10%Nozzle - mmNozzle Pressure:10-13 MPa (approx. 100-130 atm; 1400-1800 )Storage & PackingStorage:Store in a cool, dry place. Store in accordance with :1 & 4 litresSafety InformationAs a general safety measure, inhalation of solvent vapours or paint mist and contact of liquid paint withskin & eyes,should be avoided.

4 Forced ventilation should be provided when applying paint in confinedspaces or stagnant when ventilation is provided, respiratory, skin and eye protection are alwaysrecommended when spraying paint. Please refer our Material Safety Data Sheet prior to using the product.