ACCESSORIES - Tane Alarm Products

1 ACCESSORIES . Tie Wraps:TY-8 Ground Clamp Electrical Tape UL. 8 inch plastic Tie Wraps. ZINC with SS bolts Durable and Strong Sold in bags of 100. Brass Option Available 65 L 3/4" W. Clear color only. (Special Order Item) Available:White or Black Call for Min. Order Qty - Leadtime - Pricing Sold in sleeves of 10. SPADE BITS JAMBSTICK Plu Pre-Wire Plugs The JambStick is used to ensure STB-10 Plug= 3/8" Plug proper drill angles for Alarm wiring. SD-70 Plug= 3/4" Plug Assorted sizes reusable in Brown and White Telephone Block PPD-11 EZ DUCT-IT. and 18" Cord (Push Pull Disconnect) Low Voltage Wire Raceway Sold in 5 packs. Each pack contains five strips 3/8" 5/8" 5'. Total of 125'. Type Part Number RJ31 TJ-8. (8 wire block w/1 male jack). RJ31-DUAL TJ-8 DUAL. This 2 wire connector features 2 holes used EZ DUCT-IT connectors sold separately (8 wire block w/2 male jacks). to either mount the PPD-11 or to take the in 25 piece combo-packs.

2 Pressure off the wires. Available: White, Brown, Gray & Clear 61. ACCESSORIES . B-Connector (DRY FILLED w/WHITE SLEEVE) METAL PLASTIC..67"(17). (SILICONE FILLED w/BLUE SLEEVE) HOUSING COVER..224". ( ). "(26). MATERIALS: Outer Shell: Plastic Heat Shrink Tubing Contact Resistance: 10 Milli Ohoms Initial Metal Housing: Brass Dielectric: 1000 V. Inner Sleeve: Beryllium Copper plated with Bright Nickel Strength of Joint: 9 lbs TANE WS-1. (Water Sensor with Leads). The WS-1 is a low cost reliable water sensor that works on 12 VDC Alarm panels, on a 24 hr zone, open loop circuit. The wiring works similar to a two wire smoke detector. You have a red +. and black - wire inside the cable jacket. The sensor draws a very small current from the Alarm panel's 24 hr open loop circuit. When the terminals Color: White get wet the internal transistor flip flops and locks down to close the circuit, Size: 2 1/2" L 1/2" W 1/2" H causing the Alarm panel to send an Alarm .

3 P/N TANE WS-1 WH Packed 5 Note: If the Panel uses an EOL resistor, then 6 VDC is the minimum Early water damage warning w/6' foot jacketed leads requirement. Longer Leads available, 12V Operating @10 ma Note: Not compatible with wireless transmitters. Output 9V DC minimum Always test system for compatibility. TANE BOX WSPR66A 20 Watt Stainless Steel Box with Dual Tampers and Dual Tone Siren Specifications: Housing Material: Tone Frequency: Stainless Steel with Dual Reed Tampers Steady-1200HZ. Speaker Type: Warble-800HZ to 1200HZ. Voice coil impedance-8 ohm 1 second ramp cycle Rated Input Voltage: 12 VDC Operating Temp: -20 C to 60 C. Range Voltage: 6-15 VDC Dimensions: Sound Level: 115db/m "H "W 4"D. Current Draw: (144mm 143mm 100mm). AVAILABLE SPECIAL 280mA @ 12 VDC 8 ohm load Color: Stainless Steel ORDER ONLY. The TANE BOX WSPR66A Stainless-Steel Siren, can be fitted with a TANE LED STROBE. (sold separately), to provide visual as well as acoustic warnings and alerts.

4 62.