JOB SAFETY ANALYSIS WORKSHEET JSA No: Electrical …

1 JOB SAFETY ANALYSIS WORKSHEETJSA No: Electrical Conduit InstallationJob/Operation Title:10th Street MallDate:04/09/2010 Department/Division/Section:ElectricalAn alysis Developed By:Ben JohnsonLocation(s):Office BuildingParking LotWarehouseAnalysis Reviewed By:Dan RightPerson(s) Performing This Job:Bill PearsonJim RightSam CreamerSupervisor:Sam CreamerJob Start Date:04/30/2010 Duration:5 DaysTask/StepPotential HazardsRecommended Safe Job Procedures1. Pre-job set up- Hand tools- Power tools (electric, gas,hydraulic, pneumatic)Check operating condition of hand and power tools,inspect power cords for frays and nicks. Use properextension Install Hangers- Elevated loads- Elevated work platform or stairs- Hand tools- Lifting equipment (forklifts, hoists)Use forklift to raise hangers to ceiling, mark area underplatform. Tie hanger to platform to prevent dropping. Donot store hangers on Drill Hole for Hanger- Elevated loads- Elevated work platform or stairs- Hand tools- Power tools (electric, gas,hydraulic, pneumatic)Mark area under platform, keep personnel out of area,falling object hazard.

2 Locate tools and power cord tominmize tripping hazard. Gloves and eye Place Conduit- Elevated loads- Elevated work platform or stairs- Hand tools- Lifting equipment (forklifts, hoists)Lift pipe with forklift. Block area under pipe from foottraffic. Tie pipe to lift until hangers are hazards OF THIS JOBP hysical HazardsConsequencesAerial lift equipmentS-2P-1 Aerial work equipmentS-2P-3 Elevated loadsElevated work platform or stairsHand toolsLifting equipment (forklifts, hoists)Power tools (electric, gas, hydraulic,pneumatic)Awkward or static positionCaught in or between a stationary/moving objectChemical burnsCollision between moving vehicles and/or equipmentContact dermatitisElectrocution or shockExcessive lifting, twisting, pushing, pulling, reaching, or bendingExposure to excessive vibrationsEye Damage from flying objectsEye strainFalling ( < 6 feet), tripping, or slippingPenetration by sharp objectStruck by falling or flying objectStruck by moving vehicle or equipmentJSA No.

3 Electrical Conduit Installation | 10th Street Mall | Created with of 3 Unsuccessful evacuationChemical HazardsDescription/Health HazardsBENZENE(71-43-2)A clear colorless liquid with a petroleum-like odor. Flash point less than0 F. Less dense than water and slightly soluble in water. Hence floats onwater. Vapors are heavier than air. (REACTIVITY, 2003)Dizziness, excitation, pallor, followed by flushing, weakness, headache,breathlessness, chest constriction, nausea, and vomiting. Coma and possibledeath. (USCG, 1999) ACETONE(67-64-1)A clear colorless liquid with a sweetish odor. Flash point 0 F. Less densethan water. Vapors are heavier than air. Used as a solvent in paint and nailpolish removers. (REACTIVITY, 2003)INHALATION: vapor irritating to eyes and mucous membranes; acts as ananesthetic in very high concentrations. INGESTION: low order of toxicity butvery irritating to mucous membranes.

4 SKIN: prolonged excessive contactcauses defatting of the skin, possibly leading to dermatitis. (USCG, 1999) GASOLINE(8006-61-9)A clear colorless to amber colored, volatile liquid with a petroleum-like point below 0 F. Less dense than water and insoluble in floats on water. Vapors heavier than air. Leaked vapors may travel toa source of ignition and then flash back to the may be incompatible with strong oxidizing agents such as nitricacid, peroxides, and perchlorates. Charring may occur followed by ignition ofunreacted hydrocarbon and other nearby combustibles. In other settings,mostly unreactive. Not affected by aqueous solutions of acids, alkalis, mostoxidizing agents, and most reducing agents. When heated sufficiently orwhen ignited in the presence of air, oxygen or strong oxidizing agents, burnsexothermically to produce carbon dioxide and water. Biological HazardsConsequencesInsect bites or stings (mosquitoes, bees, ticks)Allergic reactionsLyme DiseaseReaction to venomRadiological HazardsDescription/Health HazardsHAZARD CONTROL MEASURES USED FOR THIS JOBA dministrative Controls:Certified operatorsInspections (ongoing) work areas, equipment, tools, instructions (equipment)Precautionary tape or barriersSafety meeting (pre-job)Trained personnelRequired Training: Electrical safetyEngineering Controls:Required PPE:Boots - steel toe and shank, appropriate solesClothing - long pantsClothing - long sleeve shirtFall protectionGloves - work glovesHard hatSafety glassesJSA No: Electrical Conduit Installation | 10th Street Mall | Created with of 3 Required Permit(s):Other Information:JSAB uilder chemical Description/Health hazards is from the CAMEO database maintained by the EPA, NOAA, and the Coast Guard( ).

5 The creator of this JSA is responsible for any edits to this = HighP-1 = HighS-2 = MediumP-2 = MediumS-3 = LowP-3 = LowJSAB uilder is the preeminent online service for creating OSHA compliant job SAFETY ANALYSIS No: Electrical Conduit Installation | 10th Street Mall | Created with of 3