Example: bachelor of science

G-code Tutorial - Tiertime 3D Printer,ABS 3D Printer,FDM ...

G-code TutorialBeijing Tiertime Technology Co., need a slicer which can generate G-code :You can use Simplify3D or other free slicers such as Slic3r, Cura, Kisslicer and etc. Here we use simplify3D as an * G-code feature is only available in UP Studio Version and later. Step 1: Load a model34 Step 2: Configure firmware Since there is no software fan control use ; to disable to corresponding commands remember to click Save when 3: Add a new Print Profile (FFF), or load existing 4: Profile ConfigurationExtrusion multiplier is recommend to set to extrusion related parameter should also multiply 20, eg. 5: Configure PrinterUse UP mini2 as an example:Go to G-code section and use the configuration shown in right.

M140 S$ uder Temp S$ Ttt atre MISO S$ Ml 'sprinter) (D r .M106 S$ ;M106 SO . ... 0.00 IOS Cooling G—Code Definition t Support G92 ED) tyve robot 33 0 Build offset 140 0 dir 0 00 ct t ... 10" G—Co de Eor print X Cooling GSO de ti General Settings G—Cod Z-1. …

Fullscreen Download

Tags:

  Code, Tutorials, M401, G code tutorial

Information

Domain:

Source:

Link to this page:

Please notify us if you found a problem with this document:

Other abuse

Advertisement

Transcription of G-code Tutorial - Tiertime 3D Printer,ABS 3D Printer,FDM ...

1 G-code TutorialBeijing Tiertime Technology Co., need a slicer which can generate G-code :You can use Simplify3D or other free slicers such as Slic3r, Cura, Kisslicer and etc. Here we use simplify3D as an * G-code feature is only available in UP Studio Version and later. Step 1: Load a model34 Step 2: Configure firmware Since there is no software fan control use ; to disable to corresponding commands remember to click Save when 3: Add a new Print Profile (FFF), or load existing 4: Profile ConfigurationExtrusion multiplier is recommend to set to extrusion related parameter should also multiply 20, eg. 5: Configure PrinterUse UP mini2 as an example:Go to G-code section and use the configuration shown in right.

2 Please note that the Origin Offset of Z axis should be equal to the nozzle height value measured from UP Studio, and you may still need to adjust this value to obtain the optimized first layer Plus 2 Configuration8UP BOX/UP BOX+ ConfigurationUP Plus 2 ConfigurationStep 6: Set Starting and Ending G-code9 Starting and Ending G-code for UP mini 2:Starting and Ending G-code for UP Plus 2:1011 Starting and Ending G-code for UP BOX/UP BOX+: Step 7: Generate G-Code1213 Step 8: Add G-code into UP Studio14

Show more