Area Luminaire
Found 6 free book(s)Calculating Light Loss Factors - Energy
www1.eere.energy.govfor area and luminaire performance data from the manufacturer – Based on “on/off” control, max/min operation temperatures, incident sunshine on luminaire and daytime heat effects. Work with manufacturer. Heat Extraction – luminaire has a thermal capacitance based on mass, specific heat of materials, and rate of dissipation. –
TABLE OF CONTENTS - Energy
www.energy.govA luminaire can have a lower LER but do a better job of dis-tributing light to the task. Lighting Power Density (LPD) Lighting power density (LPD) is the total input power (i.e., including the driver or ballast) multiplied by the total number of luminaires divided by the area in which the equipment is installed. Many energy codes use
RATIO Series - hubbellcdn
hubbellcdn.com• Low profile LED area/site luminaire with a variety of IES distributions for lighting applications such as retail, commercial and campus parking lots • Featuring Micro Strike Optics which maximizes target zone illumination with minimal losses …
DATE: LOCATION: TYPE: PROJECT: AIRO TradeSELECT CATALOG
hubbellcdn.comRETA2-XX1 Round pole tenon adapter (4 at 90 degrees) (2 3/8” OD tenon), requires CL1S-RPA4-ACC-XX for each luminaire RARBC160L Backlight Control 160L CL1S-RPA4-ACC-XX 1 Round Pole Adapter (* denotes pole diameter; 3 = 3 ¼” -3 ¾”; 4* = 3 7/8” – 6”) ASL-ARMMTG-XX11 Arm mounting kit for side of pole attachment WB-AREA-XX
Luminaires - Lighting Associates
www.lightingassociates.orgOften, modern lamp technologies require special luminaire features. For example, T-8 lamps are 33% smaller in diameter than equivalent T-12 lamps, while producing nearly as many lumens. Because T-8 lamps are brighter per unit area, proper luminaire shielding is more critical than for T-12 lamps. Luminaire Components
CHAPTER 9 TRAFFIC SIGNAL DESIGN – SUPPORTS AND …
www.tn.govsignal indications once they get to the median area. • U-Span Arrangement: U-spans are applicable at T-intersections. Advantages: o Reduces the span wire length needed. Disadvantages: o Adds signal cable length; o Depending upon the surrounding terrain, guy wires may be needed to support the strain poles. 9.1.2 Traffic Signal Mast Arm Poles