Attached 8 x 10 deck

Fairfax County Typical Deck Details

• A bracing member shall be attached to all deck joists. • Bracing shall span between the ledger board and next adjacent beam and between adjacent beams for multi-span or freestanding decks. Bracing is not required on cantilevers. • Attach bracing to each intersecting joist with 2#8 x 3-inch screws or 2-12d nails.

  Deck, Attached

HardiePanel Vertical Siding - James Hardie Pros

Figure 8 Slabs, Path, Steps to Siding Figure 9 Deck to Wall Figure 10 Ground to Siding Figure 11 Gutter to Siding Figure 14 Drip Edge Figure 15 Block Penetration Figure 16 Valley/Shingle Extension Figure 17 Min. 2 in. Min. 2 in. Min. 6 in. 1in. Z-Flashing Z-Flashing Z-Flashing Min. 2 in. Min. ¼ in. Do not caulk Extend shingles at least 1 in ...

  Deck, Vertical, Siding, Hardiepanel, Hardiepanel vertical siding

TREX TRANSCEND RAILING

2" x 8" (51 mm x 203 mm). » Top bolts must be 1" (25 mm) from tops of joists. » Bottom bolts must be 5-1/8" (130 mm) from top bolts. » Bolts can be countersunk flush with framing to allow for fascia attachment. NOTE: Blocking can be added for extra strength. 3d. Secure RSBs with 2 Installing Post Sleeve Skirts and Post Sleeves 2.

PHYSICS 111 HOMEWORK SOLUTION #10

X F~ i ~r i ˝ net = X F ir i sin i a) About the O-axis: ˝ net = 25 2 sin60 + 10 4 sin20 + 0 = 29:6 N:m This net torque is counterclockwise b) About the C-axis: ˝ net = 0 + 10 2 sin20 30 2 sin45 = 35:6 N:m This net torque is again counterclockwise 0.3 A light, rigid rod of length l = 1.00 m joins two particles, with masses m 1 = 4.00 kg and m ...

CHAPTER 18 GUARDRAILS - IHSA

spruce planks 48 mm x 248 mm (1 7/8 in x 9 3/4 in). • Make opening covers stand out with bright paint. Mark it clearly with a warning – DANGER! OPENING – DO NOT REMOVE! DO NOT LOAD! • Fasten the cover securely to the floor to prevent workers from removing it and falling through the opening. • Never stand or walk on a protective cover.

  Chapter, Guardrail, Chapter 18 guardrails