Cables Amp Equipment

BIFROST - Schiit

Connect Bifrost 2 to your source and your amp or preamp. You’ll need RCA-to-RCA or XLR-to-XLR cables to connect the Bifrost to your preamp or amp, as well as a digital cable or cables (coaxial, Toslink, or USB) to connect your source or sources. 2. If you are using USB, use a good, short cable. You need to use a 2M or less, true USB 2.0 rated

  Cable

MEGA 360 Imaging Installation Guide - Johnson Outdoors

• 1 Amp fuse Switch (optional): If you do not have a main switch or fuse panel available on your boat to connect power, you will need to purchase a battery switch. See Install the Trolling Motor Bracket, Section 3: Route the Cables and Connect Power for

  Installation, Games, Cable, Imaging, Mega 360 imaging installation

OPERATOR'S MANUAL - PrecisionUSA

controls and proper use of the equipment. 2. Never allow children to operate edger-trimmer. 3. Keep area of operation clear of all persons, par­ ticularly small children and pets. 4. Thoroughly lrain anyone using the edger-trimmer. Make sure all edger-trimmer operators know the safety, operating and maintenance procedures.

  Equipment

THR Series Guitar Amplifier Ownter's Manual

cables. Cable/s supplied with this prod-uct MUST be used. Follow all installation instructions. Failure to follow instructions could void your FCC authorization to use this product in the USA. 3. NOTE: Thisroductp has been tested and found to comply with the require-ments listed in FCC Regulations, Part 15 for Class “B” digital devices ...

  Cable

Deltran Battery Tender

The Battery Tender® charges at a rate of 1.25 Amps or 1¼ Amp-hours per hour. Therefore, a fully discharged 15 Amp-Hour battery will take approximately 9½ hours to recharge to 80% capacity. WORKING WITH A DEAD BATTERY OR A BATTERY WITH A VERY LOW VOLTAGE: If you try to charge a dead battery having a voltage below 3 volts, the