Equipment Safe
Found 6 free book(s)
DEPARTMENT OF HEALTH DIRECTORATE ... - Radiation Safe
radiationsafe.co.zasafety associated with the use of medical diagnostic x-ray equipment. The Hazardous Substances Act, 1973 (Act 15 of 1973) and Regulations (No R1332 of 3 August 1973) govern the safe use of medical x-ray equipment in South Africa. Requirements from the Act and Regulations are incorporated in this Code.
Protecting Roofing Workers - Occupational Safety and ...
www.osha.govthe care and safe use of ladders, scaffolds, fall protection systems, and other equipment they will be using on the job. Understand the requirements of OSHA’s Fall Protection standards at 29 CFR 1926, Subpart M, to protect workers exposed to falls six feet or more above a lower level. Implement safe work practices to
Hand and Power Tools - Occupational Safety and Health ...
www.osha.govThe exposed moving parts of power tools need to be safe-guarded. Belts, gears, shafts, pulleys, sprockets, spindles, drums, flywheels, chains, or other reciprocating, rotating, or moving parts of equipment must be guarded. Machine guards, as appropriate, must be provided to protect the operator and others from the following: • Point of operation.
HGV safety permit guidance - Transport for London
content.tfl.gov.ukThe Progressive Safe System will only include equipment that: • Can be retrofitted to the HGV • Is industry recognised and readily available on the market at the time • Is not cost prohibitive Exemptions A list of vehicle exemptions can be . found in Appendix A.
Guidance on the safe use of magnetic lifting devices
www.hse.gov.ukObtain sufficient information from the prospective user to ensure the equipment supplied will be safe for its intended use e.g. mass, shape, dimensions, structural stiffness, magnetic properties of the load; Provide adequate information about the use …
Safe Operating Procedures SOP 15 Oxy Acetylene Cutting ...
www.une.edu.au1. Wear proper clothing and Personal Protective Equipment (PPE). 2. Ensure this OXY welder has a suitable safe work area. 3. Ensure the equipment is fitted with appropriate flash arrest (blow back) arrest system. 4. Keep the area clean & free of grease, oils & flammables. 5. Hoses and regulators to be inspected and in good condition. 6.