High Stability Resistor Chips
Found 3 free book(s)
Lecture 17: Clock Recovery - Stanford University
web.stanford.edu• OK, as long as max drop through epi resistor is small and constant Vs rO C MAH EE 371 Lecture 17 22 Differential delay elements 1. Isolate supply with a high impedance current source 2. Increase CMRR by making signals self-referenced • Ideally we need load elements that look like perfect resistors whose value is adjusted by the control ...
8-Lead SOIC Amplifier Evaluation Board User Guide
www.analog.comThis 6-layer FR4 board design provides optimized high speed and low noise performance. First ground layer is spaced to provide 50 Ω controlled impedance with the primary layer to optimize high frequency performance. The VCC layer is sandwiched with the GND layer to provide mechanical stability and distributed interplanar capacitance
WR12, WR08, WR06, WR04 ±±1%, ±±5% Thick Film General ...
www.farnell.comEach resistor is marked with a three digits code on the protective coating to designate the nominal resistance value. 3-digits marking （±1% : 0603 ） Nominal resistance Description 1.E-24 series As 0603 WR06X ±5%. 2.E-96 series The 1st two digit codes are referring to the CODE on the table, the 3rd code is the index of resistance value :