Host Controller For A Microcontroller For
Found 9 free book(s)
Spyder BACnet Programmable Controllers
customer.honeywell.comcontroller contains a host microcontroller to run the main HVAC application and a second microcontroller for BACnet MS/TP network communications. Each controller provides flexible, universal inputs for external sensors, digital inputs, and a combination of analog outputs and digital outputs. The photo shown is the PVB6436AS, which includes the
SJA1000 Stand-alone CAN controller
www.nxp.comDec 15, 1997 · The Interface Management Logic block performs a link to the external host controller which can be a microcontroller or any other device. Every register access via the SJA1000 multiplexed address/data bus and controlling of the read/write strobes is handled in this unit. Additionally to the BasicCAN functions known from the
8-bit PIC Microcontroller Peripheral Integration
ww1.microchip.com1. Auto–tuning of internal oscillator when connected to USB host (eliminates need for external crystal) 2. Tunes internal oscillator to match accuracy of external clock source CAN: Controller Area Network Industrial– and automotive–centric communication bus LIN: Local Interconnect Network 1. Industrial– and automotive–centric ...
Digilent Pmod Interface Specification
digilent.comhost controller boards. There are six-pin and twelve-pin versions of the interface defined. The six-pin ... Microcontroller system boards are generally provided with dedicated I 2C connectors and provide pull-up resistors that are jumper selectable to be in or out of circuit. FPGA based system boards generally
MPC5554 Microcontroller - Data Sheet
www.nxp.commicrocontroller device. For functional characteristics, refer to the MPC5553/MPC5554 Microcontroller Reference Manual. 1 Overview The MPC5554 microcontroller (MCU) is a member of the MPC5500 family of microcontrollers built on the Power Architecture embedded technology. This family of parts has many new features coupled with high
NELES® ND9000 INTELLIGENT VALVE CONTROLLER
www.valin.comThe ND9000 is a 4–20 mA or fieldbus powered microcontroller-based intelligent valve controller. The device contains a Local User Interface (LUI) enabling local configuration. A PC with Field-Care software can be connected to the ND9000 itself or to the control loop. The powerful 32-bit microcontroller controls the valve position.
Next Generation Car Network-FlexRay
www.fujitsu.comEach FlexRay node consists of a controller part and a driver part (Figure 4). The controller part includes a host processor and a communication controller. The driver part typically includes bus drivers and bus guardians (optional). The bus driver connects the communication controller to the bus, and the bus guardian monitors access to the bus.
UM10360 LPC17xx User manual - Keil
www.keil.comOTG operation with an on-chip PHY for dev ice and Host functions and a dedicated DMA controller. – Four UARTs with fractional baud rate generation, internal FIFO, IrDA, and DMA support. One UART has modem control I/O and RS-485/EIA-485 support. – Two-channel CAN controller. – Two SSP controllers with FIFO and multi-protocol capabilities ...
Atmel SAM3X8E SAM3X8C SAM3X4E SAM3X4C SAM3A8C …
ww1.microchip.comHigh Speed USB Host and Device port with embedded transceiver, an Ethernet MAC, 2 CANs, a High Speed MCI for SDIO/SD/MMC, an External Bus Interface with NAND Flash Controller (NFC), 5 UARTs, 2 TWIs, 4 SPIs, as well as a PWM timer, three 3-channel general-purpose 32-bit timers, a low-power RTC, a low-