Mode Color Vin

KSZ9031RNX - Gigabit Ethernet Transceiver with RGMII Support

Config mode: The pull-up/pull-down value is latched as PHYAD[1] during power-up/reset. See the Strap-In Options - KSZ9031RNX section for details. The LED2 pin is programmed by the LED_MODE strapping option (Pin 41), and is defined as follows: Single-LED Mode Link Pin State LED Definition Link Off H OFF Link On (any speed) L ON Tri-Color Dual ...

  Dome, Color

Automatic Transfer Switch (ATS) Generator Transfer Switch ...

Mode With SW1 Off, CB1 On – Unit is in Bypass Mode ... Color Black Mounting options Stand alone, chassis or rack mounted Connections Line In Line Out ... (@ nominal Vin) 30/16 @120/230VAC Power, VA 3600 Power Factor 0.8 to 1.0 Output Voltage (nominal), VAC per UPS, Line or Generator

  Dome, Color

SC209 June 2021 SAFETY RECALL CAMPAIGN

Select ‘Special Inspection’ mode (E). 5a. 5b. Enter the vehicle information (Mileage, RO#). ... Verify that the VIN is correct. ... range, the color of rpm value displayed will change to a red color and the time counter will reset.

  Dome, Color

Technical specification for Small Form Factor Pluggable (SFP)

Bail color is blue. ... Vin 0.3 1.6 Vpp 1 Input Differential Impedance Zin 80 100 120 ohm High VfaultH 2.0 VccT+0.3 V 2 Tx Fault Low VfaultL 0 0.8 V 2, 3 ... Side Mode Suppression Ratio SMSR Min. 30 dB Eye Mask for Optical Output Compliant with Telcordia GR-253 CORE and ITU-T …

  Dome, Color

PYNQ-Z2 Reference Manual v1

Table 7.1. The peripheral controller supports SDIO host mode with 1-bit and 4-bit SD transfer modes. SPI mode is not supported. The Zynq PS UART control can be connected to the appropriate MIO pins to control the MicroSD port. MIO Pin Name 40 CCLK 41 CMD 42 D0 43 D1 44 D2 45 D3 47 CD Table 3 SD MIO pin mapping

  Dome

PYNQ-Z2 Reference Manual v1

Table 7.1. The peripheral controller supports SDIO host mode with 1-bit and 4-bit SD transfer modes. SPI mode is not supported. The Zynq PS UART control can be connected to the appropriate MIO pins to control the MicroSD port. MIO Pin Name . 40 CCLK 41 CMD 42 D0 43 D1 44 D2 45 D3 47 CD . Table 3 SD MIO pin mapping

  Dome

TrueAlert Addressable Notification Appliances

Voltage Table Jumper J1 to tap18: TrueAlert addressable wTaallp m soeuttnitn Sg/ Vin a nWda StOts units - speaker jumper setting and output ratings (25 V or 70 V audio) UL1480 reverberant at 10 ft SV/SO models ULC-S541 anechoic at 3 m SV/SO models E 1/4 78 80 F 1/2 81 83 G 1 84 86 25 V H 2 87 89 A 1/4 76 79 B 1/2 80 83 C 1 84 86 70.7 V D 2 87 ...

MAX9259/MAX9260 Gigabit Multimedia Serial Link with …

(2 x 854 x 480) Panels with 18- or 24-Bit Color Pre/Deemphasis Allows 15m Cable at Full Speed Up to 192kHz, 32-Bit Sample I2S S Multiple Data Rates for System Flexibility Up to 3.12Gbps Serial-Bit Rate 6.25MHz to 104MHz Pixel Clock Up to 1Mbps UART/UART-to-I2C Control Channel S Reduces EMI and Shielding Requirements

  Color